 Prev |
Professional Automotive Repair Technical Discussions for July 31, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2000 Chrysler Sebring JX 2.5L asd relay wont shut off with ley VIN: 3C3EL45H5Y this vehicle will stay running for a few seconds after turning off the key until the fuel pressure drops enough to stall. dealer claimed the BCM was backfeeding the circuit and after much searching we found a matching number BCM and changed it, but as I ha... |
View | |
| 2014 Ram 4500 SLT 6.7L Transmission VIN: 3C7WRKBLXE Just installed a rebuilt unit from the shop down the street. Filled with fluid, started, checked fluid level, put vehicle into gear and shifted through gears, recheck fluid level, put back into gear and noticed the vehicle did not feel like it went into ge... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2015 Chrysler 200 LX 2.4L No Start VIN: 1C3CCCAB6F Thanks to everyone who replied. Chad- I did check the BUS voltage at the DLC connector- had none. From the point on after digging around Dan hit the nail on the head, either a critter or perhaps vandalism (seeing how clean cut the harness is) Thanks Again! |
5 | |
| 2003 Jeep Grand Cherokee Limited 4.7L compressor VIN: 1J8GX58N33 Thanks everyone for the input. The evap temp sensor was disconnected in the dash. I did not find any service info or schematics for this so I am very grateful for everyone's help as I would not have figured this out easily otherwise. |
5 |
