 Prev |
Professional Automotive Repair Technical Discussions for March 31, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2003 Honda CR-V EX 2.4L Surge, Fast Idle VIN: JHLRD788X3 Vehicle had and engine replaced and has had this issue since. It had this issue on and off for a year before engine replacement. Throttle body has been replaced twice with used and once with new Honda complete no change on any of them. Engine can control i... Trouble codes: P0507 |
View | |
| 2005 Hyundai Tucson GLS 2.7L MIL Lamp on VIN: KM8JN72D05 Hey, hope everyone out there is staying healthy. This one's got me so I figured I'd run it by you guys. Customer complained about the engine light coming on after about 70 miles of driving, Upon arrival it had P0171 and P0172. No other complaints and I ver... Trouble codes: P0171 (Lean Bank 1), P0174 (Lean Bank 2), P0050 (B2S1 O2 sensor) |
View | |
| 2014 Nissan Maxima SV 3.5L Surge VIN: 1N4AA5AP1E Ok nissan guys hoping to pick your brains, customer had a p0335 code they went ahead and replaced the crank sensor with a factory one (he brought me the box ) code stays off in bay but as soon as you rev it code is pending ( no light) and car acts as the... Trouble codes: P0335 (Ckp sensor) |
View | |
| 2005 Toyota Prius 1.5L Oil Leak VIN: JTDKB20U25 This car belongs to a longtime friend. He brought this Prius to me with an oil leak. At first I thought it was the front crank oil seal, especially with 256,xxx miles. Once I got the belly cover off, I could see where an oil leak at the oil filter had wash... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2007 Honda Pilot EX 3.5L master cylinder VIN: 5FNYF28517 Thanks for your help once again. I forgot to close this weeks ago. The customer did not want to proceed anymore. What i did was i put 2 small washers on each stud that the master cylinder sits on. This increased the gap between the master cylinder and the boo... |
10 |
