 Prev |
Professional Automotive Repair Technical Discussions for September 19, 2019 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2003 Ford F-150 King Ranch 5.4L Windshield wipers VIN: 1FTRW08L13 Complaint of in-op wipers. checked fuses for this circuit-ok. Went around hi speed relay--wipers work. Went around washer relay-washers work. Checked wiper switch with ohm meter per Ford instructions--all ok. Went around switch for wiper and or washer func... |
View | |
| 2013 Ford Taurus SEL 3.5L Stall VIN: 1FAHP2E87D Everyone, we have been unable to duplicate this concern, but vehicle belongs to a lady who is normally driving alone. Vehicle will be driving normally, in the 40-50 mph range. vehicle will start shaking, throttle does not respond, and engine stalls. After ... |
View | |
| 2014 Ford F-150 XLT 3.7L Transmission Front Seal VIN: 1FTEX1EM2E Truck came in not wanting to pull. Checked the Transmission Fluid and found that it was Low. The only spot we found trans. fluid was coming out of the bellhousing. Removed the transmission and the front seal looked good and the Torque converter looked good... |
View | |
| 2010 Lincoln MKT EcoBoost 3.5L fuel smell at rail VIN: 2LMHJ5AT7A We can smell fuel by injector rail (cannot see any thing wet) very hard to see, Rail is between cylinder heads. We lifted plenum crank engine saw no fuel leaking remove foam from under plenum put plenum back in place and started engine can smell fuel canno... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2014 Ford Focus SE 2.0L No Start, Cuts out, Stall, MIL Lamp on VIN: 1FADP3K2XE Good morning techies, We ended up just swapping the PCM with a remanufactured one brought in by client; had the PCM programmed to key/vehicle and it started up. We also recommended the customer to get a second key as well for us to program both keys to vehic... Trouble codes: U0109, P0103 (Mass Or Volume Air Flow Circuit High Input), P025A. |
12 |
