 Prev |
Professional Automotive Repair Technical Discussions for December 28, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2008 Ford Edge Limited 3.5L Monitors not ready VIN: 2FMDK49CX8 Hello Friends and thanks for reading this. Here we go again. Another vehicle that has monitor readiness issues. IN this case, it will not set readiness on any Non continuous monitors EXCEPT EVAP. I have seen the EVAP monitor run few times naturally or a... Trouble codes: C0AT, EVAP, 02, 02, HEATE |
View | |
| 2011 Ford Fusion S 2.5L Cooling Systems VIN: 3FAHP0GA6B Vehicle came in with check engine light on. Cylinder head over temp. Condition and cylinder head over temp. Protection active. Replaced thermostat and instantly vehicle started to run rough, temp gauge jump to hot immediately. Coolant in vehicle was full. |
View | |
| 2005 Lincoln Navigator 5.4L Ride Height VIN: 5LMFU27595 Ride height spec's/procedures call for calculating the difference between: the lower knuckle surface to floor and the center of the rearward lower control arm bolt to floor (front trim height - 85mm/3.4") and: the difference between the lower edge ... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2008 Ford Escape Hybrid 2.3L high voltage battery VIN: 1FMCU49H38 The repair for this vehicle is not related to the 12 volt battery or the theft system. the pcm never sees the crank request from the ignition switch. I installed a ignition switch and the vehicle started with a screwdriver. I installed the switch in the lock h... |
5 |
