 Prev |
Professional Automotive Repair Technical Discussions for October 16, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2006 Chrysler 300 C 5.7L Hesitation, Cuts out, Stall, MIL Lamp on VIN: 2C3KA63H96 checked tcm and pcm termminals checked tcm and pcm power and grounds check body and engine grounds and repaired intermittently engine dies may or may not restart right up usually will restart if it doesn't will kick on cel light and both codes come back p0... Trouble codes: P0700, U0100 |
View | |
| 2003 Dodge Ram 2500 Van 5.9L No Start, Stall VIN: 2D7JB21Z63 Van stalls intermittently. Occasionally it will not restart. "No bus" message comes on the dash and gauges start acting up. New customer. I have no previous service info. Van came in originally for the starter bucking while cranking over and running po... |
View | |
| 2003 Jeep Liberty Limited 3.7L Blend Door VIN: 1J4GL58K03 This car came in with the blend door stuck cold. The ACTUATOR was replaced and seemed to work until it hits full hot. Then is stuck there till you cycle the key off and turn it to cold. Then turn the key. The heat and a/c work very well in this jeep. I als... |
View | |
| 2006 Jeep Wrangler Sport 4.0L won't run all ready VIN: 1J4FA49S86 Jeep runs and drives great, solid 4.0 L engine with good oil pressure. Jeep will not pass inspection because o2 heater and evap will not run. We did replace the battery because of an issue with the ignition allowing the key to come out while on. Finall... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers |
