 Prev |
Professional Automotive Repair Technical Discussions for April 16, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2006 Dodge Dakota SLT 3.7L coils,plugs VIN: 1D7HE48K56 First checkedfor dtc's found p2314 coii 5 insufficient ionization . That is when i checked wires from pcm, and asd relay. They checkek good. Diag then said pcm. So i agreedand could not get a reman from manufact. For 3months. So i found a place to rebuild ... |
View | |
| 2012 Dodge Durango SXT 3.6L MIL Lamp on VIN: 1C4RDHAGXC Do Chrysler 3.6 engines have trouble with timing chains like the GM 3.6 liter engines?Vehicle came in with overheating due to headgasket issue.I replaced the headgaskets and when I was part way through the torque procedure the threads pulled out of the block o... Trouble codes: P0019 (crank-cam correlationBank 2Sensor 2), P000A, P000C |
View | |
| 2007 Jeep Wrangler Unlimited Sahara 3.8L cluster, wipers, shifter VIN: 1J4GA59107 I just replaced the timing cover gaskets and oil pan gasket and now the cluster, wipers, shifter interlock are all INOP. And I have a U0155(No comm with cluster). I checked all fuses in engine fuse block(including swapping each maxi fuse one by one), swapped ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2005 Chrysler 300 C 5.7L convertor VIN: 2C3AK63HX5 The torque converter was the problem. I ended up just replacing the entire transmission, car had almost 100,00 miles. Thanks for all the replies. A couple of the posts described it as driving over rumble strips and that is exactly how it felt. It would only do... |
11 | |
| 2007 Dodge Caliber SE 2.0L Wheel Bearing VIN: 1B3HB28B67 The fix for this ended up being an OE bearing from Dodge. I stated in my post that I was sure that the bearing was installed with the correct side inward for the sensor to pick up the tone ring, so some where not reading very well. The way the bearing was be... |
14 |
