 Prev |
Professional Automotive Repair Technical Discussions for April 11, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1993 Ford Probe 2.0L Rear Main Crankshaft Seal VIN: 1ZVCT20A5P This is going to sound silly, but I am wondering if anyone with experience with the 2.0 Ford engine can remember specifically servicing the rear main seal before? On the bottom of the seal retainer, there are two studs that extend through the bottom block ... |
View | |
| 2008 Ford F-250 Super Duty XL 6.4L Stall VIN: 1FDSX20R98 had 3 injectors missing so replaced all injectors driver said was going in to limp mode. I don't think it was going in to limp mode .After replacing injectors idles fine will run for a bout 2 miles and acts like it is running out of fuel let it set 4to5 minute... |
View | |
| 2010 Ford F-150 STX 4.6L Compressor VIN: 1FTMF1CW4A Customer original concern: ac cycling 30 secs on 30 secs off. All temperature sensors are reading properly. Ac pressure slightly below spec. Attempted to replace transducer, no change. Replaced ac kit. Concern still present. Low side pressure drops to 15 p... |
View | |
| 2013 Ford Escape SE 1.6L Poor Idle Quality, Poor Idle Quality VIN: 1FMCU0GX4D Hi, thank ya'll so much an advance. I have this nightmare 2013 ford escape 1.6 turbo.the original engine ran strong and had full power,no check engine light. It was just knocking. Installed the used engine now im getting a p0017 and has no power. I checked... Trouble codes: P0017 |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2009 Ford Escape XLT 3.0L power assist VIN: 1FMCU03G89 Wound up installing a used column and vehicle now performs correctly. The original module would not allow position learn. Did not even have to reflash replacement unit to get proper operation. This was not done on advise from a mobile diagnostic tech who claim... |
10 | |
| 2016 Ford Explorer XLT 3.5L Stall VIN: 1FM5K8D88G It has been a little bit and it appears it is fixed. The PCM was the fix. Doing the live network test wiggling, tapping and tugging on a cold car as it warmed up produced no results. The hotline archive did not have any results, only issues with PCM codes. The... Trouble codes: U0100 (PSCM PAM ABS lost communication w/PCM), U0401 (PSCM PAM invalid data from PCM). |
7 |
