 Prev |
Professional Automotive Repair Technical Discussions for February 28, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2004 Ford F-150 FX4 5.4L Cuts out, Misfire, MIL Lamp on VIN: 1FTPW14534 Engine runs very bad, tried unplugging maf, no difference, we looked into the cats, bank2 partially plugged,disconnected pipe fromm manifold, still runs bad. used motorvac fi cleaner to try using remote fuel ran the same. Trouble codes: P0340 (cmp b1 circuit fault), P0352 (coil b pri circuit2 cylinder), B1484 (brake pedal input circuit open) |
View | |
| 2011 Ford F-150 Platinum 3.5L Hvac Mode Door VIN: 1FTFW1ET5B Truck came in with air only blowing out of face vents. Found mode door actuator bad and replaced it. After replacement, mode door worked fine twice then will only blow of of defrost. We didn't know there was a reset procedure for actuator, so we replaced i... |
View | |
| 2013 Ford Edge SE 2.0L Surge, Stall, MIL Lamp on VIN: 2FMDK3G94D Hi everyone, Kindly I need your help on this Ford Edge, most of the times the engine stalls on acceleration it acts like it's cutting fuel and it will pick normally after and always on cold start the rpm will be high and when it will reduce the engine w... Trouble codes: P2195 (O2 Sensor Stuck Lean) |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2009 Ford F-150 XLT 5.4L Stall, MIL Lamp on VIN: 1FTPW14V39 The truck came back last Friday and would not run for more than 2 minutes before it stalled. the fueul pump module was shutting off. while the truck was running we wiggled the wire harness around. when we moved the harness just in front of the left spring hang... Trouble codes: U210B. |
6 | |
| 2011 Ford F-150 Platinum 3.5L Radio VIN: 1FTFW1ET9B Per customer request, left START signal removed. Radio works as expected. Terry, the APIM only had a B1D79 Microphone Input error. START signal comes from PCM to starter relay and ACM. I'm going to assume that there is a wire or connector issue from spli... |
2 |
