
![]() |
Professional Automotive Repair Technical Discussions for December 15, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Asian
Help Request | Answers | |
2006 Honda Odyssey EX 3.5L Idle VIN: 5FNRL38796 This van is idling rough. Mostly in park, but it will do it after a while in drive also, but only when stopped. You can tell that it is misfiring when the idle becomes rough. Van drives great, no problems when you are moving. It is throwing a P15AE code, w... |
View | |
2009 Honda Fit Sport 1.5L Misfire, MIL Lamp on VIN: JHMGE88469 Help Honda Techs!! This fit sets misfire codes in all cylinders.customer states the engine has always ran fine when this happens. we have tested compression, leak down, fuel trim is at 1.02 long and short- all spot on. We have replaced the rear o2 sensor w... Trouble codes: P0301 (p0302-), P0302 (p0303-), P0303 (p0304-), P0304 |
View | |
2013 Mazda CX-9 Grand Touring 3.7L No remote start VIN: JM3TB3DV5D Looking for some help on this Mazda remote start. Remote start is not working. Vehicle goes through normal start procedure but will not crank. It tries for 4 times then aborts. Vehicle starts and drives normally all other times. The remote start system is ... |
View | |
2006 Toyota Prius 1.5L Vibration with acceleration 55-75 VIN: JTDKB20U46 Customer complaint is a vibration at highway speeds. Test drove with customer, there is a vibration at 55-75mph. It goes away when you release the throttle. It's present above 75, but not as strong. The vibration fairly severe. Not Jeep-death-wobble bad, b... |
View |
Fixes & Summaries for Asian
Fix/Summary | Answers | |
2006 Lexus GS300 3.0L No Start VIN: JTHCH96S86 Hi to all.since I cannot update anymore information,iwill add it here.in response to Timothy [...] reply,I labscoped the signal from the ecm to the driver module,for the pressure regulator,its not there. The injector signal from the ecm to the driver modul... |
5 |