
![]() |
Professional Automotive Repair Technical Discussions for October 30, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Chrysler
Help Request | Answers | |
1987 Jeep Cherokee 4.0L Hesitation, Cuts out VIN: 1JCMR7711H This Jeep will rev to 2700 rpm loaded or unloaded and will not rev any higher. It's like it hits a rev limiter at 2700 rpm. I have scoped crank position, cam sync (new distributor), timing signal. The crank signal is good, the cam signal was not good until I p... |
View | |
2012 Jeep Grand Cherokee Laredo 3.6L reverse shift and drive shift VIN: 1C4RJFAGXC delayed engagement up to 5-7 second in reverse or drive doesnt really matter if transmission temp is hot or cold sometimes it will go right into gear |
View |
Fixes & Summaries for Chrysler
Fix/Summary | Answers | |
2008 Dodge Caliber SE 2.0L MIL Lamp on VIN: 1B3H628BX8 Replaced Intake with Dealer supplied part (no aftermarket avail). Intake come with all attached sensors including the IMT. Started vehicle within 2 seconds IMT actuator self tested and passed without further fault. I did take the other intake apart (suspecte... Trouble codes: P2015. |
10 | |
1950 Willys 4-63 .0L rear seal VIN: J2F835TA39 Thanks for the replies. All 18 recommended going to a rope seal. Thanks to Al [...] for the part numbers. Fel-Pro # is BS 3165; Victor # is JV687.I actually found one at my local O'Reillys. Turns out the same seal fits 70-71 jeep cj5 with 4 cyl. I did run acr... |
18 |