 Prev |
Professional Automotive Repair Technical Discussions for September 8, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2006 Honda Accord EX 3.0L MIL Lamp on VIN: 1HGCM66526 Car came in with 2 codes- p0443 (purge valve) and p0498 (canister vent shut valve), both circuit malfunctions. Checked the valves via activation with a power probe and activation through scanner, ohm tested, and checked the associated fuses. (#18 for purge, ... Trouble codes: P0443, P0498 |
View | |
| 1991 Mazda RX-7 Turbo 1.3L Excessive Emissions, Stall VIN: JM1FC3523M I have this rx7 that I just installed a reman engine in and I am having trouble getting it to take a load. I can get it to idle and accelerate good but when put into drive it dies. I have set timing by book and checked the map sensor.i don't do very many rx7 s... |
View | |
| 2013 Nissan Maxima S 3.5L Steering VIN: 1N4AA5AP9D Hello out there. This Maxima has a loud clunk up front that can be felt in the steering. It seems to follow acceleration on take off and somewhat when turning the wheel. You can feel it in the steering wheel. You do not have to go over a bump.I work for a GM d... |
View | |
| 2005 Toyota 4Runner SR5 4.0L MIL Lamp on VIN: JTEBU14R55 At a loss... I replaced the head gaskets on this 4 runner 3 months ago. It came back a month later with p0174. Fuel lt trim on bank 2 was +7. Trim on bank 1 is 0/0. Smoked it, and replaced b2s1 because i thought the wave form looked funny. No change. Swapped t... Trouble codes: P0174 (Lean bank 2) |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2003 Toyota Tundra SR5 4.7L steering wheel VIN: 5TBBT44193 I want to thank everyone foe the great suggestions, especially Mark [...]'s suggestion of using a pyrometer to check rotor temps! Well, we found we had a bad NEW RF caliper & we also replaced the front hoses. The truck still had a slight pull, so we checked th... |
10 |
