
![]() |
Professional Automotive Repair Technical Discussions for August 23, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Ford
Help Request | Answers | |
1994 Ford F-250 XL 7.3L Hard Shift VIN: 1FTHX25K3R Truck came in with O/D light flashing and hard shifts all the way until overdrive. Checked for codes with the snap-on verus. Found code 23 tested the the signal and at idle was .3 volts at idle and 3.5 WOT. Wiggled the connection and dropped slightly but not a... Trouble codes: 23 (TP/Fuel Injection Pump Lever Sensor Out of Range) |
View | |
2004 Ford F-250 Super Duty XL 6.0L No Start VIN: 1FTNW21P94 Truck came in after it died on the highway, and would not restart. Batteries were low, they were charged and starter was found to be locked up. Replaced starter. Now- have ficm sync and adequate voltage in and out at crank. Have low side oil pressure. Have ad... Trouble codes: P132B, P2291 (Icp to low) |
View | |
2007 Ford Fusion S 2.3L Surge VIN: 3FAHP06Z77 Ford fusion came into my bay with a engine surge when wait at a traffic light, test drove and confirmed a rpm swing from 500-1000 and almost stalling near 500 rpm. cleaned the MAF and Throttle body, no change. as per iDENTIFIX hits replaced drive by wire throt... |
View | |
2009 Ford F-150 XLT 5.4L oil pressure VIN: 1FTPX04V49 tested oil pressure. cold oscillating like ive never seen between 40-70 warm in gear between 20-40 at 1500 rpm between 50-70 a little less needle movement. engine in clean inside valve cover. I felt lifters don't seem to be pumped up much. suspecting oil pump.... |
View |
Fixes & Summaries for Ford
Fix/Summary | Answers | |
2007 Ford F-150 XLT 5.4L IWE hubs, vacuum loss? VIN: 1FTPW14597 Finally got this one back in for further testing & repair, found vacuum check valve right near the IWE solenoid was leaking, replaced and all is well with vacuum supply now, thanks for all the replies. God bless. |
13 |