 Prev |
Professional Automotive Repair Technical Discussions for July 11, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2004 Ford Explorer Sport Trac XLT 4.0L No Start, Stall VIN: 1FMZU77K94 Vehicle came in with complaint of stalling and not always restarting when hot.It had a new crank sensor and ignition coil already installed.I scanned computer and got code PO320 for Ignition/Distributor engine speed circuit fault.I let truck run in my bay,afte... Trouble codes: P0320 |
View | |
| 2012 Ford Escape XLS 2.5L Expansion Valve VIN: 1FMCU0C70C This is the third time the vehicle had been in for this issue. We performed a quick test on the system the first time and suspected compressor. When it came back on day it was scheduled we found that the expansion valve was at fault. Remove and replace valve a... |
View | |
| 2012 Ford Escape XLT 2.5L Mechanical VIN: 1FMCU9D79C Hello all, NEVER seen anything like this one. Vehicle comes in with fans running on hi, no compressor engagement. First checked pressures to find that low side is a normal 70 psi but hi side is 370 psi! (without compressor running). Recovered all refrigerant... |
View | |
| 2003 Mercury Mountaineer 4.0L Hesitation VIN: 4M2ZU86K23 Stuck on this one - car came from another shop that had put a new MAF Sensor on it. Complaint was that engine would just lay down on power at times. Scanner data shows that upstream O2 Sensors drop to double digits and stay there while LT FT is -20s both Banks... Trouble codes: P2195 (O2 Sensor Excess Lean Signal Bank 1 - Sensor 1) |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2008 Ford Expedition XLT 5.4L blower motor VIN: 1FMFU15548 found the wire to the blower motor relay wasnt making good contact so it wouldnt ground the relay repaired the wire and is all good thanks for all the help |
4 |
