 Prev |
Professional Automotive Repair Technical Discussions for July 6, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2003 Chrysler Town & Country LX 3.8L MIL Lamp on VIN: 2C8GP44LX3 This van came in for check engine light on. Scan engine controller for data and codes found pcm code p1491, bcm, orc, havc code. Since the van needs to pass the smog test, pcm code needs fixed. When scan with autel maxisys, p1491 is fan control relay circuit. ... Trouble codes: P1491 (Fan controlled relay circuit using autel maxisys), P1491 (Fan controlled relay circuit using autel maxisys) |
View | |
| 2011 Chrysler 200 Limited 3.6L blend door VIN: 1C3BC7EG7B Problem started with a failed compressor. Replaced unit and was plagued with leaks at connections and finally a pinhole in the condenser. Each time a leak repair was done, the AC would blow ice cold. Finally all leaks were fixed and now the AC will blow warm t... |
View | |
| 1995 Dodge Dakota 5.2L Hard start, misses, VIN: 1B7GL23Y6S Battery dead, charged, load test pass, crank ok no start like no fuel , pressure test 40 psi ok, spark at coil ok, injector pulse ok, shot of ether - nothing just cranking, loosen exhaust crossover and during cranking it reluctantly started, suspect cat, ran f... |
View | |
| 2012 Dodge Grand Caravan SE 3.6L Steering VIN: 2C4RDGBG9C Car arrived with bad crank pulley and the belt shredded. The belt had damaged the front seal on the power steering pump. We replaced the pulley , belt and ps pump and test drove vehicle . It did well for the first 2 miles then steering started to get hard. Tho... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2003 Chrysler Sebring LX 2.4L No Start VIN: 4C3AG42G13 thank you everybody for your support and advise , this car is fixed but unfortunately none of the replies were helpful , but thank you very much anyways , the problem was a loose connection on the controller which was cutting the signal to the computer and tu... |
10 |
