 Prev |
Professional Automotive Repair Technical Discussions for June 12, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2000 Mazda MPV DX 2.5L Engine VIN: JM3LW28G0Y The car has a no star no crank condition. When you put the key into the ignition and try to start, the horn honks a few times and the hazardous lights flash as well. No crank, nothing. We checked for codes, no DTC's and communication with PCM. Then we checked ... |
View | |
| 2004 Toyota Highlander 2.4L MIL Lamp on VIN: JTEGD21A94 Reoccouring P0171, MAF didn't help.My freeze frame info RPM 2270,57 mph ,25% throttle coolant 183 degrees, air flow 20.43 gs, short term fuel trim 10.1%, long term 32.7%. I looked at the air tube closely, it seems good, Im wondering about the intake manifold g... Trouble codes: P0171 (lean) |
View | |
| 2007 Toyota Tundra Limited 5.7L compressor VIN: 5TBDV58127 Truck came in no A/C. Recovered freon and charged to specs. Still no A/C. Had loose connection at A/C relay, not making contact with relay at fuse box. Repaired connection and replaced relay, found signs of mice in fuse box. repaired broken wire under fuse box... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2010 Hyundai Santa Fe GLS 2.4L transaxle VIN: 5NMSG3AB7A I haven't got it fixed yet but we are going to put a transmission in it. I have tried discharging and relearn the pcm a couple of times and I would get about 100 miles before it started again. I've even tried another pcm and it did the same after 100 miles. I ... |
9 | |
| 1996 Kia Sportage 2.0L U-joints / Driveshaft VIN: KNDJA7230T Thanks for all the input. I will check U joints with Driveshaft removed. I'll also check pinion. I have over tightened a nut and crush sleeve for pinion before so I'll check that if U-joints don't move smoothly with Driveshaft removed. Thanks everyone. Really ... |
13 |
