 Prev |
Professional Automotive Repair Technical Discussions for June 1, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 1999 Nissan Frontier SE 3.3L MIL Lamp on VIN: 1N6ED26Y6X Nissan Vehicle came in for smog check with incomplete obd monitors, Customer drove one week and return with check engine light for code p1336, ckp sensor. ohm test crank sensor at 680 ohms, specs from Mitchell was 230oh at 70f, check with new crank sensor , sa... Trouble codes: P1336 (Crank sensor pos) |
View | |
| 2010 Nissan Titan SE 5.6L A/T check, limp mode VIN: 1N6AA0EJ9A This vehicle got towed in because it was leaking fluid. We found one of the transmission cooler lines had failed causing fluid loss and damaging transmission. After repairing the line, the transmission had no reverse and barely moved forward. We installed a re... |
View | |
| 1994 Toyota Camry LE 3.0L No Start VIN: JT2GK12EXR Hi All, DTC p1300 Igniter Circuit Malfunction, Ran "Circuit Inspection diagnostic". Step 1-7 passed, Step 8 FAILED Check voltage between terminals IGT 1 - 6 of ECM and body ground (says voltage should be .5 to 1 volt.). So i replaced ECM with used.. Re-test a... Trouble codes: P1300 |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2008 Honda Fit Sport 1.5L No Start, Stall, MIL Lamp on VIN: JHMGD38648 This vehicle was repaired shortly after the update. We found the fuel pump to have a bad segment, as evidenced by hooking a scope up to the fuel pump circuit. She had water in her gas tank as well. New pump and fuel fixed the vehicle. Thanks again to all who h... Trouble codes: P0171 (Fuel metering too lean). |
18 | |
| 2006 Subaru Forester X 2.5L Keyless entry VIN: JF1SG65636 Based on the two replies, this system works exactly as discussed, the customer sets the alarm by hitting the door lock switch next to the P/W switches. The alarm sets. Because his fob doesn't work he has to cycle the ignition switch a few times which turns of... |
2 |
