 Prev |
Professional Automotive Repair Technical Discussions for April 27, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1997 Ford F-150 XL 4.2L Misfire VIN: 1FTDF1826V Currently working on this ford p/u has a misfire on Cylinder # 2 & Cylinder # 6, checked for spark & found no spark on both towers of coil, checked power at coil and found 12v , changed coil and same issue, checked for grounding from pcm & found small pulsing ... Trouble codes: P0353 (Ignition Coil C Primary/Secondary Circuit Malfunction) |
View | |
| 2004 Ford F-250 Super Duty King Ranch 5.4L Engine Noise VIN: 1FTNW21L34 See related history. Vehicle has had salvage motor put in. Mostly all engine related parts came with the salvage engine. After engine replacement, unit started right up fine, vehicle ran normal. No apparent issues, other than a rhythmic knock/tap. Sounds slow... |
View | |
| 2004 Ford F-550 Super Duty XL 6.0L Hard Start VIN: 1FDAW57P74 Truck came in with what the customer said was a no start when warm and an hour later it would start fine. Confirmed it was a hard start warm but with 15-20 seconds of cranking the icp would build and the truck would start. I have replaced the icp sensor due to... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1995 Ford F-150 Eddie Bauer 5.0L Excessive Emissions, Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Poor Fuel Economy VIN: 1FTDF15N0S So after 3 A1 Cardone re manufactured Air Flow Meters we ordered a Standard Air Flow Meter and its fixed. This one was tough. I started to question my diagnosis but could find nothing out of range. Thanks for all the help and be careful who you get your parts ... |
13 | |
| 2008 Ford F-250 Super Duty XLT 5.4L Steering VIN: 1FTSX21548 Hey guys, thanks for all the help. Took pitman arm loose to take box and column out of equation, which were fine. Squeezed out some more caster with new slugs and had minimal results although there was a definate improvement. Snatched out Moog ball joints in f... |
24 |
