 Prev |
Professional Automotive Repair Technical Discussions for February 23, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for GM
| Help Request | Answers | |
| 2008 Chevrolet Avalanche LS 5.3L Transfer Case VIN: 3GNFK12378 Transfer case is stuck in neutral truck will not move.I have no lights on the shift selector(they light for a bulb check then go out)it has 5v ref on gray pin 11 and good ground on pin 6 blk. At the transfer case encoder motor connector pin A tan wire shows 12... |
View | |
| 2009 Chevrolet Traverse LT 3.6L MIL Lamp on VIN: 1GNER23D79 My main concern is the P0366 right now. If code is cleared it returns right away. FYI the engine has been rebuilt. That work was not done here and though I have asked so far no one can tell me why that was done. I have done basic ckt tests (5v ref, ground at c... Trouble codes: P0366 (Bnk 1 exhaust cam sensor performance), P0332 (Bnk 2 Knock sensor) |
View | |
| 2012 Chevrolet Equinox LT 2.4L Poor Idle Quality, Hesitation, Surge, Cuts out VIN: 2GNFLNEK1C car was here about a month ago had a lazy vvt solenoid now back no codes no light on but after gets hot with in gear starts to buck an hesitates like wants to stall out short term fuel goes to -2 long term stays around 12 |
View | |
| 2008 GMC Yukon XL 1500 SLE 5.3L 4wd VIN: 1GKFK16368 I have this Yukon here with a customer complaint of 4wd won't disengage. Pulled code C0306 05 Short to B+/open motor circuit, code won't clear. Going thru diagnostics it tells you to check both motor inputs for short to ground. intermittently I get 1.9 mega oh... |
View |
Fixes & Summaries for GM
| Fix/Summary | Answers | |
| 1998 Chevrolet K1500 Cheyenne 5.7L slave cylinder hose VIN: 1GCEK14R0W We tried the ny-tie band-aid and it was working when the customer drove it home. We advised we would have to replace the slave and the line for a confirmed fix. Have not heard back. Thanks again for all the replies, Steve. |
8 |
