 Prev |
Professional Automotive Repair Technical Discussions for January 5, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1986 Ford Mustang LX 3.8L Motor Mounts VIN: 1FABP2838G The motor mounts on this car has an adjustable bolt built into them, can anyone explain how to adjust or if adjustment is needed? |
View | |
| 2004 Ford F-350 Super Duty XL 6.0L Draw VIN: 1FDWX37P64 Truck cam in for a draw, checked and found a 1.8 voltage to the glow plug relay, injector pressure regulator, EGR valve actuator, cooling fan module until the battery saver module shuts down, then the voltage drops to .03 volts. which is enough to keep the glo... |
View | |
| 2011 Ford Fusion SE 3.0L Defaults to 5th gear in drive VIN: 3FAHP0HG0B Hopefully someone has insight to my headache. This 2011 Ford Fusion came in with P0751 and P2700 and in limp mode. Line pressure tests were good. Found the lock lever at the trans multiplug broken but plug intact and seated. Tested wiring for opens/shorts/cont... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2000 Ford Taurus SE 3.0L No Start VIN: 1FAFP55U8Y The pcm was the problem, several suggestions for wiring to the crank sensor but this was all good. Swapped in a used computer and had locksmith match keys and she fired right up. Did repalce alternator with correct unit and repaired wirng. Thanks for the help,... |
13 | |
| 2003 Ford Explorer Sport Trac XLS 4.0L no crank in park VIN: 1FMZU77E53 First off, yes, the scan data ALWAYS showed the correct gear. Looking at the wiring diagram, the park/neutral portion of the switch is separate from the circuits that would show up in the scan data. Even so you would think if the switch was not in Park, the sc... |
11 | |
| 2010 Ford Escape XLT 2.5L MIL Lamp on VIN: 1FMCU9D74A Thanks to all the guys that replied it was very helpful. Customer has not returned with the Escape as of yet, I did replace the vent solenoid. Trouble codes: P0456 (Small Leak). |
7 | |
| 2010 Ford Escape XLT 2.5L Axle Bushing Removal Tool VIN: 1FMCU0D72A This Escape is fixed!! I ended up taking a piece of 3/8" thick flat bar 11/2" long and 3/4" wide, drilled and threaded a hole in the middle of it too thread my slide hammer shaft into. I rounded the edges so that it followed the curve of the bushing but no bi... |
8 | |
| 2011 Ford Escape XLS 2.5L Park Will Not Disengage VIN: 1FMCU9C77B THE OLD STOPLIGHT SWITCH HAS A CLIP THAT MUST BE DISENGAGED IN ORDER TO COMPLETE THE GROUND. HOWEVER, THIS PART OF THE SWITCH WAS FAULTY. I ORDERED THREE DIFFERENT SWITCHES FROM THREE DIFFERENT VENDORS AND RAN INTO THE SAME PROBLEM. THIS IS WHEN I REALIZED TH... |
11 |
