 Prev |
Professional Automotive Repair Technical Discussions for December 23, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for GM
| Help Request | Answers | |
| 2000 Chevrolet K3500 LS 7.4L Hesitation, Surge, Misfire, MIL Lamp on VIN: 3CEZ9AF008 Vehicle keeps throwing a po300 code, when you go to the misfire counter history there are high numbers an most cylinders. At idle it very rarely showed any misfires also when you drive hard under loading you will not feel or see any misfires. The only time the... Trouble codes: P0300 |
View | |
| 2005 Chevrolet Equinox LS 3.4L No Start, EGR Monitor VIN: 2CNDL13F55 The suv came in for the EGR monitor not running to completion. All other monitors are completed and there is no DTC code neither any pending. All the DTC tests for the EGR had run except the P0401. The criteria for DTC P0401 are decelerating from 55 MPH and th... |
View | |
| 2001 GMC Sierra 1500 SL 5.3L low pedal running VIN: 1GTEK19T81 We started this project out with a typical bad flex hose on the Rt. front which caused an excessive brake drag. We replaced both rotors, new pads and flex hoses for both front sides. We bled the system and got all air out without engine running. Pedal was hard... |
View |
Fixes & Summaries for GM
| Fix/Summary | Answers | |
| 1998 Buick LeSabre Limited 3.8L headlights VIN: 1G4HR52K4W Hello All and thank you for all the posts. I did finally fix this issue. The switch on the driver door was getting power intermittently - but even when getting power did not trigger the headlights. long story short - i replaced the module (near the gas ped... |
21 | |
| 2009 Chevrolet Impala LS 3.5L Heating VIN: 2G1WB58K79 First of all, I'm sorry it took so long for me to get back to everyone. Been a very busy couple weeks. Thank you to everyone that replied. We did remove the water pump to inspect the impellers. They looked fine and the pump felt pretty good. Reinstalled the sa... |
20 |
