 Prev |
Professional Automotive Repair Technical Discussions for December 19, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1999 Ford F-150 Lariat 5.4L Lack of heat VIN: 1FTRX18L5X This Ford is being difficult! A week ago, came in for lack of heat. Had about 85*F duct temp and one hot and one cold heater hose. Flushed the heater core, got 152*F duct temp. Customer drove for 3 days, came back with not so hot temps again (90*F). Same scena... |
View | |
| 2004 Ford F-550 Super Duty Lariat 6.0L Fuse 28 Blower Motor VIN: 1FDAF56P84 Just using this as information to help anyone else out with this problem. Fuse 28 in the Central Junction Block blows as soon as vehicle is put in drive with the engine running. Fuse 28 powers the blower motor relay, therefore the blower motor would quit runn... |
View | |
| 2004 Ford Focus ZX3 2.3L Poor Idle Quality, Cuts out, Stall, Misfire, Poor Fuel Economy, MIL Lamp on VIN: 3FAFP31Z94 Car starts up rough when cold with the High\low idle for a bit,I can tap gas and it will smooth out.STFT goes to + 42%,LTFT will start going up to about + 8%, with no O2 sensor switching.If I tap the gas several times O2's start switching and runs fine. If I l... Trouble codes: P2195, P2270, P2274 (B1S2 stuck lean) |
View | |
| 2005 Ford F-550 Super Duty XL 6.0L Long crank to start VIN: 1FDAW56P85 Replaced stand tubes with ford update kit pressure tested found top o-rings on injectors leaking replaced most of the orings pressure tested again no leaks found with 120psi shop air assembled test ran it and got engine up to operating temp number 8 injector m... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2001 Ford F-350 Super Duty Lariat 7.3L Cuts out VIN: 1FTSW31FX1 Ok- Solution found- Humble pie. It was a spike generated in the 5v ref line by the Exhaust Back-pressure Sensor. (I even have one in stock) I know the evils of this sensor from years of fixing powerstrokes, but this is the first one that fooled me so badly. ... |
22 |
