 Prev |
Professional Automotive Repair Technical Discussions for December 2, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1994 Ford F-350 XL 7.3L Excessive Emissions VIN: 1FTJW36F7R This truck came to us running rough, no power, lots of fuel smoke. Worst cold but still pretty bad warm. After the basic tests we checked compression (all about 400psi) and removed the injectors and send them in to be tested. Six of the eight failed the high i... |
View | |
| 2003 Ford F-350 Super Duty XLT 6.0L Cuts out, Stall VIN: 1FTWW33P43 On first start up truck will start up and run for a few mins and kill like you turned the key off. Will start right back up and run for a min kill again .. after that it will run all day start and stop. Tried another ficm, ipr , crank and cam, unplugged the ic... |
View | |
| 2006 Ford F-350 Super Duty XLT 6.0L long crank time VIN: 1FDWF37P16 I'll gloss over what I've fixed already, but the hard cold start still persists. Batteries test fine, cranking RPM 190-230, no self test engine codes, ICP builds quickly to match desired, AND voltage climbs as high as 1.2 volts before it will kick, and starts ... |
View | |
| 2011 Ford F-150 Platinum 3.5L Engine VIN: 1FTFW1ET6B Customer brought truck in check engine light on, low on power, noise at times. Verified codes present, 1 Qt low on oil and slightly overdue. Noise very loud at idle sounds like timing chains or guides slapping cover (similar to older 3v). Rev the truck up to a... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1976 Ford F-250 Ranger 6.4L emissionapplications VIN: F25MRA7676 Thankyou all for your statements.I copied and added them to a stack of documents to give to my customer for future smog checks. There is no evap and never was. I have Holley building a new carb 50 state legal.And I can prove the specs through my research which... |
10 | |
| 1996 Ford Aerostar XLT 4.0L transfer case VIN: 1FMDA41X4T Thank you everyone for the replies! It helped a lot. We ended up changing the throttle position sensor, and it fixed the problem. We tested multiple sensors and it all came back to the throttle position sensor. Thanks again for the replies |
7 | |
| 2003 Ford F-250 Super Duty XLT 6.0L No Start VIN: 1FTNW21P43 Fix did indeed end up being the FICM module. During programming of new module I had forgotten to take out FICM relay and the injectors were rattling during programming. Didn't seem to effect anything in programming. Was a relief to hear the injectors come b... Trouble codes: P0261 (Cylilnder 1 injector circuit low), P0264 (Cylinder 2 injector circuit low), P0267 (Cylinder 3 injector circuit low), P0270 (Cylinder 4 injector circuit low), P0273 (Cylinder 5 injector circuit low), P0276 (Cylinder 6 injector circuit low). |
6 | |
| 2008 Ford Escape XLT 3.0L ABSmodule VIN: 1FMCU03118 Sorry everyone forgot about this one with holiday last week. I have not fixed this one yet. We are borrowing it from the inlaws right now and I have time with it. I am going to look into reprogramming the module like some of you said can be done. If this thing... |
9 | |
| 2013 Ford F-250 Super Duty Lariat 6.2L Surge VIN: 1FT7X2B65D Well it is fixed short story replaced the fuel pump and module, long story the pump is a 2 speed pump, the low speed is pulse modulated and therefore when the pump get weak it cannot deliver the volume needed to cruise speed and was switch back and forth to hi... |
8 |
