 Prev |
Professional Automotive Repair Technical Discussions for November 28, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2006 Chrysler 300 C 5.7L Excessive Emissions, Poor Idle Quality, Misfire, Poor Fuel Economy, MIL Lamp on VIN: 2C3LA63H76 Customer just purchased this car from a used car lot around a month ago. Brought it in for the pre-purchase inspection and it had a misfire. Lot installed a new set of OE Champion plugs and sent him on his way. Made it about 2 weeks and started running rough, ... Trouble codes: P0208 (8 Injector fault) |
View | |
| 2007 Chrysler Pacifica Touring 4.0L Right axle seal VIN: 2A8GF68X47 Found a leaking right axle seal on this all wheel drive Pacifica. Did some research and found that the PTU has a inner and outer seal for the axle shaft. Chrysler states that the unit must be removed and split to drive the inner seal out from the inside but sh... |
View | |
| 2003 Dodge Ram 1500 Laramie 5.7L Misfire VIN: 1D7HU18D13 Hey and thanks in advance for everyone's help on this one. I purchased this truck with a blown engine ( was ran out of oil and broke a rod). So with that being said have no previous repair history other than what we have done and do not know if the misfire was... Trouble codes: P0305 (Misfire cyl 5) |
View | |
| 2008 Jeep Liberty Limited 3.7L 1st & 2nd gear VIN: 1J8GN58K98 Customer complaint of what feels like posi-traction shudder on acceleration. This vehicle does not have differential or transfer case clutches (MP1522 transfer case). Drive line and u-joints, mounts are all good. New tires on all 4. Trans Fluid level was corre... |
View | |
| 2012 Ram 5500 Laramie 6.7L transfer case VIN: 3C7WDNFL7C In 4WD HI there is a chatter noise that starts about 30km/h and is only present when accelerator is pressed. When foot is released from accelerator the noise will stop until you reach about 25 km/h on the decel. When driving in 4WD HI and noise is present, I b... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers |
