 Prev |
Professional Automotive Repair Technical Discussions for October 19, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2005 Chrysler PT Cruiser Limited 2.4L Hesitation VIN: 3C8FY68855 Has hesitation cold for about 4-5 min. After that hesitation is gone. Only when accelerating from a stop are these symptoms present, after that car runs great with plenty of acceleration/power. Maybe jump timimg? cts is reading correctly. Feels like lack of fu... |
View | |
| 1999 Dodge Ram 2500 5.9L MIL Lamp on, trans in limp mode VIN: 1B7KC2366X We installed a loaner PCM and the engine starts and runs. The transmission is still in limp mode due to lack of relay output voltage. We tested all circuits from the PCM to the transmission control relay - Ok. We tested the relay - Ok. We find the relay energi... Trouble codes: P0743 (Torque Converter Clutch Solenoid/Trans Relay Circuit) |
View | |
| 2009 Dodge Sprinter 2500 3.0L MIL Lamp on, limp mode VIN: WDYPE74589 Vehicle came in in limp mode, scanned pcm and found DTC 3156 (Boost Pressure Implausible Value) Parameters showed it at 800 hpa with engine off and engine running. I believe it should be reading the same as the intake pressure sensor with KOEO (300 hpa) Smoked... Trouble codes: 3156 (Boost pressure sensor implausible valve -01) |
View | |
| 2004 Jeep Grand Cherokee Limited 4.0L Hesitation, Cuts out, Stall, MIL Lamp on, Harsh Buck VIN: 1J8GW58S84 Jeep came in for losing power when driving down the highway. Check engine light is not on. Performed testing and found no codes current or in history. Test drove on highway and Jeep has a violent buck and will not accelerate for about 2-4 seconds. Other times ... Trouble codes: P1391 |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2001 Jeep Grand Cherokee Laredo 4.0L No Start, MIL Lamp on VIN: 1J4GW48S41 Thank you everyone once again for your assistance. No modules were replaced. I found a broken wire in the driver door rubber boot. Brown w/ yellow tracer color. I soldered it and wrapped it heavily with black tape. I found a mysterious red wire added from th... Trouble codes: P1686 (SKIM code set. Immobilizer circuit active. No SKIM bus signal.). |
14 |
