 Prev |
Professional Automotive Repair Technical Discussions for October 13, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2006 Chrysler 300 Touring 3.5L No Start VIN: 2C3KA53G16 Have no start with no communication from any control module. Tried 2 different scan tools. Can spray starting fluid through throttle body and engine will run for 5 to 10 seconds. Really not sure what to test next, other than need to establish communication wit... |
View | |
| 2004 Dodge Sprinter 2500 2.7L abs module VIN: WD2PD743X4 hi everyone, got this wonderful 04 sprinter here that is a mess hoping for some additional guidance to help get the trans out of limp mode to begin shifting again. originally came in on a hook with a no start. was able to drive it in to shop after using a jum... |
View | |
| 2006 Dodge Ram 1500 ST 3.7L Misfire, MIL Lamp on VIN: 1D7HA16K76 Howdy Y'all This 06 Dodge Ram has intermittint loss of spark on cyl#6. Sometimes it has no current ramp and 0 for coil burn time. When it came in was dead most of the time. I pulled the connector C2 at ECM and checked pin for loose fit (OK compared to others) ... Trouble codes: P2317 (Ionization CYL 6 missing signal at times), P0306 |
View | |
| 2007 Dodge Sprinter 2500 3.0L Excessive Emissions VIN: WD0PE74517 Had this question on the H/D forum , but no help there, so the dpf filter is clogged and the new filter I got on ebay is a week out, the customer needs to use it while we wait , so if I put a pipe in the place of filter will it go into limp mode , and turn off... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2004 Jeep Liberty Limited 3.7L 2-4 shift VIN: 1J4GL58K64 Thanks for all the replies. I'm not sure if it's fixed, it has been one week since the customer pick it up and it's not back yet. What I ended up doing was running a new wire for the sense circuit with new terminals at the solenoid pack and pcm. Thanks again f... |
3 |
