 Prev |
Professional Automotive Repair Technical Discussions for September 2, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2007 Dodge Ram 2500 SLT 5.9L No Start VIN: 3D7KS29C17 Replaced tipm 4x4 burnt up new tipm installed no crank old tipm starts and runs |
View | |
| 2006 Jeep Commander 4.7L Pulls My wifes car and its getting worse, when you travel at freeway speeds 55 or greater and let off the gas, it jerks to the right and then straightens out. Checked ball joints, good. Control arm bushings are good, trans and motors mounts are good. Rear diff bushi... |
View | |
| 2014 Ram ProMaster 3500 3.6L Misfire, MIL Lamp on VIN: 3C6URVJG1E This truck came in with a P0301 Misfire Code... It would not miss till it was warm and when I Current Ramped the coils I didn't have the Ramp for Coil #1... I shut the truck off and installed a Test Coil and i didnt have a Miss anymore.. After installing the... Trouble codes: P0301 (Misfire Cylinder 1) |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2008 Chrysler Town & Country Touring 3.8L ABS Module VIN: 2A8HR54P78 Once again IATN saves the day! Thanks to those who replied. Took van to shop with a Witech (factory) tool and they had no problem initializing the ABM. I did find out that the Witech had a couple of additional steps that both the Modis & Genisys EVO did not pr... |
4 | |
| 1989 Dodge Dakota 3.9L No Start VIN: 1B7GL26X6K Thanks Dan, Sure enough it was the ignition coil. The spark appeared strong visually but apparently wasn't, Replaced the coil Starts right up and runs fine |
22 |
