 Prev |
Professional Automotive Repair Technical Discussions for August 22, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1993 Ford Ranger STX 4.0L No Start, Cuts out VIN: 1FTCR15X0P Vehicle came in as a starts and dies after 10 minutes of driving concern. Found fuel pressure to be at almost 90 psi. Replaced fuel pressure regulator and fuel pump. Vehicle still has similar concern. Unable to get dtcs from computer. Have tried scan tool and ... |
View | |
| 2003 Ford F-350 Super Duty XLT 6.0L Starter VIN: 1FTSW31P33 Vehicle has a no crank condition. Pcm codes p0706 and p0707. Followed diagnostic routine for digital trans range sensor-torque shift transmission. Harness continuity from trans connector to pcm is good. Power to trans range sensor is a pass. Power to the pcm r... |
View | |
| 2003 Ford F-350 Super Duty XLT 6.0L Manafold VIN: 1FTSW31P03 Thanks for any help on this Vehicle. I'm Replacing the exhaust Manifold on the left side. It has 4 broken bolts. My question is what is the best way to get these out. Having trouble getting on them. Any help will be appreciated. Thanks Rick |
View | |
| 2006 Ford Expedition Limited 5.4L Cht VIN: 1FMFU20506 Check engine comes on for a po119 Engine coolant temperature sensor 1 circuit intermittent/erratic. replaced the coolant head temp sensor last week and code is coming right back. Temp Readings are good on dash and scanner. From my research there is not a sep... |
View | |
| 2006 Ford Taurus SEL 3.0L Starter and ignition system VIN: 1FAFP56U16 This car came in for a no start, no crank. with power applied to starter relay it cranks but there is no ignition with key on. found no communication with anything as long as the PCM is connected found a U1900 stored in the IC not sure if it is because the PCM... |
View | |
| 2009 Ford Flex Limited 3.5L No Start, Cuts out, Stall VIN: 2FMEK63C09 Hello All, I have a Ford Flex that was towed in after it stopped running while driving. The customer states he was doing 55 mph down the road and the vehicle stopped running. It would crank but would not restart on the side of the road. He had it towed back to... |
View | |
| 2012 Ford Focus SEL 2.0L valve cover VIN: 1FAHP3H2XC working at Chevrolet used cars. got a 2012 ford focus in for a dime sized hole in the valve cover above the exhaust camshaft and low power. car ran fine around the block, was full of oil although Idk if they filled it before coming in. no codes present in pcm.... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2007 Ford Fusion SE 3.0L MIL Lamp on VIN: 3FAHP07197 I hate to do it, but I had to send this one to the dealer. I believe the problem was internal ECM, and I am not equipped to program. Thanks for the replies Trouble codes: P0642. |
4 | |
| 2006 Lincoln Zephyr 3.0L Srs VIN: 3LNHM26106 sorry guys car still has not returned, When he comes back I will post repair. Thank for info. I will be looking at in point test C |
14 | |
| 2006 Mercury Mariner Premier 3.0L MIL Lamp on VIN: 4M2YU56126 Thanks you for your help. I was able to test both purge and vent solenoids there were both ok. cleaned everything from dirt. Disconnect ftp sensor, connector was covered in dirt. Took the car for a ride, before the voltage for the ftp would go below .5 volts a... Trouble codes: P1450 (Unable to bleed fuel tank vacuum). |
3 |
