 Prev |
Professional Automotive Repair Technical Discussions for June 16, 2016 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 1999 Honda Accord EX 2.3L No Start, Cuts out, Stall VIN: 1HGCG6673X customer came in with stalling problem. scanned system and found no codes. drove vehicle from cold and after about 5 miles of driving vehicle loses power and dies and will not restart. hooked scanner to vehicle and monitored RPMS while cranking and noticed RPM... |
View | |
| 2002 Honda Civic LX 1.7L No Start, Poor Idle Quality, Stall VIN: 2HGES155X2 Car was throwing 2 permanent codes p1362 and p1361. It was also throwing a temporary code p0420. these codes only showed up after a test drive for 15 to 20 minutes with the AC on. When the codes come the car has a severe loss of power and will not hardly go ab... Trouble codes: P1362 (Tdc sensor1 no pulse), P1361 (Tdc sensor1 noise), P0420 (Catalyst system efficiency below threshold) |
View | |
| 2003 Honda Pilot EX 3.5L no compressor VIN: 2HKYF18673 We replaced the compressor because the clutch coil bad, after replacing the compressor will run for about 2 minutes then cut off. the compressor will not come back on till you turn it off for about 10 min then it will cut it back on for about 2 min. No codes i... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2006 Toyota Camry XLE 2.4L AC Light VIN: 4T1BE32K86 First of all thank you to everyone who replied. The problem was no signal from the control head to the amplifier, thus no compressor engagement, I disassembled the control head and found bad solder joint on the circuit board, repaired solder joint, reassembled... |
16 |
