× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 26, 2016
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1993 Ford Ranger STX 4.0L Excessive Emissions VIN: 1FTCR10X3P
inherited this truck from another shop, failing the ASM testing for NOX and HC's. running a base line test i found that fuel trims are going crazy. at idle im watching my o2 sensors and decided to graph my fuel trim also. bank 1 was switching like an o2 sensor...
View
2002 Ford F-350 Super Duty Lariat 7.3L Poor Idle Quality, Stall, Misfire VIN: 1FTSW31F72
This vehicle came in with a engine oil leak. Diagnosed HPOP leaking, removed to reseal but it was damaged during the procedure so I had to replace the HPOP with a reman pump. After repairs test drove vehicle 2 times (total of about 20mil) all was ok. Then star... Trouble codes: P1211 (ICP not controllable - pressure above/below desired)
View
2010 Ford Edge SEL 3.5L Drive-axles VIN: 2FMDK3JC6A
Vehicle has a noticeable "wobble" at slow accel from stop-sets up at 25mph and ends at 40mph-it is load sensitive-quits when you let off accel,locked it in low gear-still there,power brake with engine at same rpm-1200-1500-not there.it is also most noticeable ...
View
1999 Lincoln Town Car Executive 4.6L Air Condition VIN: 1LNHM81W2X
hello everyone thanks for any help ac did not work evacuate and recharge it had about 1 lb to much freon after it runs about 5 minutes with blower on compressor will turn on and it cools fine replaced low pressure switch no chance i have a snap on verus pro ha...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1998 Ford Mustang GT 4.6L high pressure VIN: 1FAFP42X9W
everyone that said condenser got it right. replaced condenser and that solved the pressure problems. thank you for all the help.
40
2003 Ford F-250 Super Duty XLT 6.0L Hesitation, Stall VIN: 1FTNX21P73
Well this truck is finally down the road. A motorcraft FICM fixed the problems. Just goes to show that aftermarket stuff is junk. I installed a new ficm and programmed.
10
2004 Ford F-350 Super Duty XL 6.0L No Start VIN: 1FDWF37P74
Thanks to all the helpful members out there who have more experience with these things, I was led to checking the HP oil system with air via fitting attached to the ICP sensor port. After doing this, I was unable to hear or find a leak in the HP system. The ma...
17
2005 Ford F-350 Super Duty King Ranch 6.0L Accessories VIN: 1FTWW31P45
I am sorry for taking so long to get back to you guys,the truck is fixed.Well the instrument cluster is problem.When i sent the cluster out for repair the first time,they did not fixed,they said every thing tested out good,so i have to test every thing out aga...
9
2010 Ford Fusion SE 2.5L brake pressure VIN: 3FAHP0HA7A
Joe hit it right on. There was no pressure at the left rear and the right front put new master on and bleed all is good thanks guys for the info.
7
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next