× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 7, 2015
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
2003 Honda CR-V EX 2.4L MIL Lamp on VIN: SHSRD788X3
See above repairs-tested oil pressure at vtec solenoid oil pressure switch-we only have 8 psi with v-tec applied-engine oil pressure at block is 44plus psi at 3000 rpm-have cleaned all screens-removed head and inspected oil passages-appear to be clear???-Where... Trouble codes: P1259 (VTEC Malfunction)
View
2006 Honda Accord EX 2.4L MIL Lamp on VIN: 1HGCM56806
Greetings! This code will set only on the first cold-start acceleration of the day - give it too much throttle and and bucks, turns on MIL and sets code. Pull over, shut it off, restart and you're good to go. Not sure if the oil pressure switch is normally ope... Trouble codes: P2647 (Rocker Arm Oil Pressure Switch VTEC Oil Pressure Switch Circuit High Voltage)
View
2007 Hyundai Sonata GLS 2.4L pcm VIN: 5NPET46C57
Hello Techs, I had my body shop drop off this vehicle that had an engine replaced in another facility. The vehicle runs great and there are no noted issues until the car was to be inspected to find that there is no communication with the PCM by use of the OBD ...
View
2007 Infiniti G35 X 3.5L Poor Idle Quality VIN: JNKBV61F47
I've replaced the engine that was hydrolocked by flood. After repair, Idle hunts up and down (1000 to 1800 rpm). Performed idle relearn, disconnected 3 injectors, relearn says "complete" but still up and down idle after reconnecting injectors. Replaced ECM and... Trouble codes: P0507
View
1994 Lexus SC400 4.0L Blower Motor VIN: JT8UZ30C4R
Found this thing blowing only in the highest two positions. tried blower motor resister, power transistor and control head and still no change. Looked for Cell Phone but cannot find option on this car. Very hard to diagnosis this diagram as I am not familiar w...
View
2004 Mazda RX-8 1.3L Poor Idle Quality, MIL Lamp on VIN: JM1FE17344
Hello every one, thanks in advance for your time. This mazda came in to the shop for no start from a body shop, first i found fuse for alternator and other fuse for ecm bad, after replace all the fuses bad, engine start with check engine light with code p2106 ... Trouble codes: P2106 (Throttle actuator control system-forced limited power)
View
1990 Nissan Maxima GXE 3.0L Excessive Emissions, MIL Lamp on VIN: JN1HJ01P3L
Hello every body and happy holly days.we are looking for some help with this maxima. check engine light is on, dtc 33, o2 sensor circuit open or high volt set. well, we replaced the o2 sensor after found it switching too slow. test drove, same code 13 reset. w... Trouble codes: 33 (Oxigen sensor open ckt or high o2 signal)
View
2003 Nissan Altima SE 3.5L sets p0021 at idle VIN: 1N4BL11D53
this 3.5 keeps setting a P0021 at idle. car came in for timing chain issue & we replaced chain & guides with oem nissan parts & the chain lined up perfectly. the car runs great & has no issues except for code. replaced the solenoids with oem parts & really at ...
View

Fixes & Summaries for Asian
Fix/Summary Answers
2007 Honda Civic LX 1.8L Poor Idle Quality, MIL Lamp on VIN: 1HGFA16527
Thanks for all the help. I had a friend of mine do the idle relearn with the HDS and all is well. I tried the relearn procedure that doesn't require the HDS and had no luck. The car is fixed and the customer is happy. Trouble codes: P1129 (MAP sensor circuit higher than expected), P0507 (Idle air control system high than expected).
18
2006 Mazda Tribute S 3.0L Charging VIN: 4F2CZ96126
Thanks for all the help. It turned out to be that the alternator was not grounding even though it was bolted up. Added a ground cable from the strut tower to the alternator mounting bolt and it started charging at 13.8. So to all the people that keep getting w...
23
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next