 Prev |
Professional Automotive Repair Technical Discussions for November 2, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2007 Chrysler Sebring Touring 2.7L Suspension VIN: 1C3LC56RX7 I have a noise coming from the front of the car going over small bumps at slow speed. To me sounds like the drumming of a strut. I have just replaced struts, boots, bumpers, mounts and bearings due to the bearings making noise while turning. The noise was ther... |
View | |
| 2008 Jeep Patriot Sport 2.4L ABS light VIN: 1J8FF28W58 Initial repair concern was for c2116 pump voltage low. Antilock controller and pump were replaced and initialzed. ABS functions perfectly and no codes are stored in CAB or instrument cluster. No diagnostic info exists for this symptom in Shopkey /Mitchell. Any... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2003 Dodge Ram 3500 5.9L Instrument cluster VIN: 3D3LU396X3 Success! This one is fixed. Tested all powers and grounds for the cluster and found no fault. Got the labscope from our R&D department and watched the signals on the PCI bus. Disconnected all the other modules on the bus except the cluster, and connected the D... |
7 | |
| 1997 Jeep Grand Cherokee Laredo 4.0L Hesitation, Misfire, MIL Lamp on VIN: 1J4GZ58S4V Thanks all for the help. After testing the wires, harness, connections and sensors and reviewing the current state of tune and performance we've discovered a lot of little things adding up to and including intermittent problems. Sensor check running - no faul... Trouble codes: P0300 (General Misfire), P0301 (Cy 1 Misfire), P0301 (Cy 1 Misfire). |
13 | |
| 2001 Jeep Cherokee Sport 4.0L Misfire VIN: 1J4FF48S81 I am closing this as not fixed yet but we are pretty confident we have the fix. The issue was what might be causing the #1 cylinder injector to be erratic and then stop working. We'll send the ECM in for repair (injector driver type of thing). When we ins... |
10 |
