 Prev |
Professional Automotive Repair Technical Discussions for October 29, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2000 Ford F-250 Super Duty Lariat 7.3L oil/fuel VIN: 1FTNW21F9Y Vehicle failed to restart after extended trip. Towed in by customer-engine cranks-no start. Checked fuel filter & found contaminated with engine oil. Sample from fuel tank also full of engine oil. Diagnosed as faulty injector o-rings. Pulled all 8-injectors. P... |
View | |
| 2008 Ford F-250 Super Duty XLT 6.4L Transfer cas VIN: 1FTSW21R08 Ok all you ford gurus, i need some help. Ihave a first time cutomer whose truck is stuck in 4 wheel drive low.i have 2 transfer case codes p1876 and p1832, and the 4 low light is flashing. Followed mitchel on demand trouble chart brings me to 4x4 module, talke... |
View | |
| 2010 Ford F-150 STX 4.6L left front VIN: 1FTEX1E82A Customer replaced pads, rotors calipers, and hoses. now only the left front is sticking. I checked to may sure that the wheel bearing wasnt sticking, its ok. Any ideas |
View | |
| 2005 Lincoln Navigator 5.4L Poor Idle Quality, Hesitation, MIL Lamp on VIN: 5LMFU28555 Good evening peers. I've got this Navigator with timing codes. Based on information I found here it either points to low oil pressure, or faulty timing components. I'm a bit hesitant to tear it apart to simply just throw parts at it without first getting some ... Trouble codes: P0012 (Intake Camshaft Position Timing Over Retarded Bank 1), P0021 (Intake Camshaft Position Timing Over Advanced Bank 2) |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2007 Ford Fusion SEL 3.0L Poor Idle Quality, Misfire VIN: 3FAHP02137 I am going to call this one fixed even though it is not done yet. I did as most of you suggested. I had an old fog light in the shop and the ohms of resistance were nearly identical to the coil so I hooked it up to Cylinder 5 and started the car, no light. I t... |
8 |
