 Prev |
Professional Automotive Repair Technical Discussions for October 23, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1994 Ford Mustang GT 5.0L Cuts out VIN: 1FALP42T6R Thank you in advance for any help. First things replaced were the fuel pressure regulator and ignition pick up coil because the engine would start and stall out when warmed and lost spark. After we got it running, it had a stumble at 3500-400 rpm. We have trie... |
View | |
| 1996 Ford F-150 Eddie Bauer 4.9L Poor Idle Quality, rough running VIN: 1FTEF15Y1T Ok, thanks in advance. Have this truck here customer states it runs bad intermittently. I have had it running or driving around the last 2 days and in that time it has acted up for a told of roughly 20 seconds. I don't completely trust the data because it has ... Trouble codes: P0133, P0171, P0174, P0153, P1151, P1131 |
View | |
| 2001 Ford Windstar LX 3.8L window/turn signal/cluster VIN: 2FMZA51411 Accessory Delay Relay coil is not grounded by FEM intermittently. No codes. If Windstar sets for several hours all relays controlled by FEM are not grounded by there respective drivers in the FEM. After ignition is turned on (10 min. or several hours) the FEM ... |
View | |
| 2010 Ford Escape XLT 2.5L MIL Lamp on VIN: 1FMCU0D7XA Vehicle has P2096 code. No TSBs found. Intake and exhaust systems have been smoke tested, no leaks present. Fuel pressure 55-60 PSI at all times. STFT@ Idle: 1.6 LTFT@ Idle: 8.6 STFT@ 3K RPM: 3.5 LTFT@ 3K RPM: 5.5 MAF readings accurate, no dropouts or... Trouble codes: P2096 (Post Catalyst Fuel Trim System Too Lean Bank 1) |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1983 Ford F-150 XL 5.8L No Start, Stall VIN: 1FTDF15G3D After further review and discovery, found that we were not thorough. The crank sensor failed after warm up, scoping the incoming signal from ckp and outgoing to module we see the ckp signal dropping out when warm. Replaced the crank sensor. |
1 | |
| 2006 Ford Five Hundred SEL 3.0L power steering VIN: 1FAHP24136 The customer took vehicle to dealer to reprogram and dealer wanted $850, they said forget it and will just put up with problem. Thank you to the guy that gave me the service bulletine on it. It made since and disscribed everything exactly. |
4 | |
| 2008 Ford E-250 5.4L MIL Lamp on VIN: 1FTNE24L68 THANK ALL U GUYS FOR THE HELP THE PROBLEM WAS THE IGNITION COILS CHANGE THEM VAN RUNS OK ALSO THE SECOND PROBLEM WAS THE WIRING GOING TO THE THROTTLE BODY WIRING WAS BROKEN WIRING FIX THE WIRING OK THANK YOU GUYS AGAIN |
20 | |
| 2010 Ford F-150 FX4 5.4L climate control VIN: 1FTFW1EV8A The HVAC module fixed this. I tried reprogramming the old one with as built data before replacing it. Also tried the battery disconnect but in the end new module was the fix. Thanks for the replies. |
1 | |
| 2010 Ford Fusion Hybrid 2.5L warning lights as most of the replay suggested master cylinder fix it , I never felt any loss of brake on the pedal , Thanks to everyone that offer help. |
5 |
