 Prev |
Professional Automotive Repair Technical Discussions for October 12, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1950 Ford F3 3.9L Surge, Cuts out VIN: 98RY338647 When driving under 35mph feels a little sluggish but no complaints from customer.When he tries to go above 45mph in 4th gear the truck kicks and bucks like crazy.Not sure what my next move is. Ant suggestions would be greatly appreciated. |
View | |
| 2000 Ford F-350 Super Duty XL 7.3L Cuts out, Stall, Misfire, MIL Lamp on VIN: 1FDWW37F7Y Truck bucks and intermittently stalls under hard acceleration, seems worse cold. When issue is occurring truck will set P0344 and P1219. Have replaced cam sensor and tried another known good sensor, overlayed 12v and ground from pcm to cmp and spliced in new 5... Trouble codes: P0344, P1219 |
View | |
| 2003 Ford F650 7.2L blower motor and resistor VIN: 3FDNF65AX3 hello all and thank you in advance, let me start with the truck came in with two fifty amp fuses blown, traced it back to a not so good house wire feeding straight from the ignition to the blower motor and then to the compressor clutch. ripped all that out, re... |
View | |
| 2011 Ford F-250 Super Duty XL 6.2L BCM Programming VIN: 1FDBF2A62B Ford Techs I a little lost with this one. I programmed the BCM (PMI). I did get the message to program/learn the BCI no problem, here's the rub I "think" I programmed the tire pressure by entering the pressures 65#ft 80#rear but I'm not sure it took, and I can... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1997 Ford F-250 XL 5.8L Blinker VIN: 1FTHF26H8V I have fixed this truck and after help from you guys it was a very simple and embarrassing fix. I don't work on Fords very much so after some said to check to make sure the flashers are off I did. The button should be down to be off. There was nothing wrong wi... |
27 |
