 Prev |
Professional Automotive Repair Technical Discussions for August 18, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2003 Chrysler Town & Country LX 3.3L Pcm VIN: 2C4GP44313 Thanks in advance, i have this chrysler mini van, that was towed in no start/ no crank. Tested starter it's good, batt. Good, jump power to starter it cranks but no start.can not communicate with pcm. Scan all mods and come up with codes i think never saw this... |
View | |
| 2005 Dodge Ram 2500 Laramie 5.9L Misfire VIN: 3D7KS28CX5 we are trying to smog this diesel truck and the truck has to have all the monitors cleared.the misfire monitor will not reset.there are no faults and the check engine light is off.we adjusted the valves and the truck runs fine. |
View | |
| 2005 Dodge Ram 3500 SLT 5.9L monitors not setting VIN: 3D7LS38C15 I have been trying to get this Dodge to pass the California emission test and can not set the monitors to complete. It came in with only the misfire monitor complete while the comprehensive component and fuel system were incomplete. I have updated it with soft... |
View | |
| 2004 Jeep Grand Cherokee Laredo 4.0L MIL Lamp on VIN: 1J4GX48S24 Hello everyone and thanks for the help with my confusion. I have this 2004 GC 4.0 engine that was in 2 weeks ago for a check engine light. We fixed the EVAP code and there was a P0137 stored. We installed a new Denso oxygen sensor and the thing is back with t... Trouble codes: P0137 (B1S2 oxygen sensor low voltage) |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1996 Dodge Ram 3500 5.9L Hesitation, Surge, Cuts out, Stall, Misfire VIN: 3B7MC33CXT I just want to say thanks to everybody, because actually the truck had 2 problems, it does have low compression so its getting an overhaul, but the run bad problem was pump timing even though we put it in on TDC and aligned the pump timing peg, I wasn't taking... |
20 |
