|Prev||Professional Automotive Repair Technical Discussions for April 24, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2005 Dodge Ram 3500 SLT 5.9L oil pressure VIN: 3D7LS38C25
I have little to no oil pressure after a rebuilt long block was installed. I have gone back in and replaced the oil pump and pick up tube with cummins oem parts. I have removed and replaced the filter adapter gaskets with oem parts. That's the extent of my end...
Fixes & Summaries for Chrysler
|1996 Dodge Ram 2500 5.9L no power steering
Okay so I pulled the p.s. and vacuum pump off again. I pulled the vacuum pump apart and where the p.s. splines into the vacuum pump there is a washer and a collar, the collar has a roll pin which was broken. The p.s. works now but the brakes don't have good bo...
|2005 Dodge Ram 2500 SLT 5.7L Engine VIN: 3D7KS28D25
Sorry I have to close this request without fixing the problem. Suggestions varied from an exhaust leak, valve seats, piston slap, to the condition is normal. Customer did not want to dig deeper. I issued a partial refund and washed my hands of it. Thanks to al...
|1999 Jeep Grand Cherokee Laredo 4.0L No Start VIN: 1J4GW58S5X
Jon was right! The customer didn't have too much money to get this vehicle repaired so I did switch the wires like jon said and it fired up with no problems. So I guess ill just leave the old coil on it. Thanks everyone.