
![]() |
Professional Automotive Repair Technical Discussions for March 19, 2015 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Ford
Help Request | Answers | |
2007 Ford F-350 Super Duty XL 6.0L No Start, Hesitation, Stall VIN: 1FDWF37P77 This vehicle intermittently stalls because of loss of high pressure oil. IT DID THIS BEFORE THE COOLER WAS REPLACED! It can idle for hours without stalling. This afternoon I changed the IPR valve with a used one I had on hand. I left it idle two hours, then to... |
View | |
1999 Lincoln Navigator 5.4L Poor Idle Quality, Cuts out, Stall, Misfire, MIL Lamp on VIN: 5LMPU28A6X car was put back together ran fine drove for 30 kilometers when I felt a vibration came to a stop it was misfiring then smoothened out but continued to do it intermittent under load or other wise we checked the compression its good pulled plenum replaced gaske... Trouble codes: P0307 |
View |
Fixes & Summaries for Ford
Fix/Summary | Answers | |
2003 Ford Focus SVT 2.0L MIL Lamp on, Lack of Power VIN: 3FAHP37573 What I did, bring the crank up to TDC using a screwdriver in #1 cylinder. Screwed in the crank pin down on the side of the block, then lined up the RIGHT notch on the crank with the mark on the pan. Lined up both cams using the plate in the back of the cams. T... Trouble codes: P1383 (Intake Cam Over Retarded). |
6 | |
2007 Ford E-250 4.6L Water Pump VIN: 1FTNE24W87 Well so far so good haven't seen the Van in 2 weeks buy its gone that long before. I replaced the fan clutch and the pulley seemed to wobble there was a updated parts where you had to replace both parts |
9 |