|Prev||Professional Automotive Repair Technical Discussions for March 9, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2000 Chrysler Sebring JXi 2.5L Hesitation, Cuts out, Misfire, MIL Lamp on VIN: 3C3EL55H0Y
This car has been all over town for the same problem. Sometimes it runs OK until it warms up real good, other times it starts up and runs poorly right off the bat. The car will idle all day long smooth as silk but when you give it throttle, it stumbles, misses... Trouble codes: P1391
|1969 Plymouth Fury Sport 6.3L steering gear VIN: PH27H9D272
help.. steering wont return to center in fact wont return at all. stays in the turn even with engine shut off.can remove all the fluid from gear and pump and remove the belt to make it manual steering and the car has good return.set alignment to 1.75 degrees p...
Fixes & Summaries for Chrysler
|2002 Chrysler 300M 3.5L control head VIN: 2C3HE66G52
my tech is closing this,tim,jerry,pat,richard got it.i separated the circuit board and plugged in as was able to get to work.the aera top right corner near the voltage stabilizer,3 resistors appeared to be the problem.i resoldred all 3.could not get to fade/dr...
|1999 Dodge Ram 1500 Van 5.2L cruise control VIN: 2B6HB11Y7X
The problem is the on off switch. I used a switch out of a customers 98 dodge 1500 and everything works as expected. Problem is the new switch that I got from the dealer causes the voltage to drop to 4.5v and the used switch stays at 5v. The only issue im havi...
|2007 Dodge Durango SLT 4.7L engine
HELLO TO ALL I DID REMOVE ENGINE FROM TRUCK.. DID LIKE YOU GUYS TOLD ME. UNBOLT TRANSMISSION PULL IT BACK FOR 1/4 " ,REMOVE INTAKE MANIFOLD AND ATACH LIFTING POINTS IN MIDLE OFF ENGINE BLOCK.. ENGINE IS OUT .. HARDEST PART IN ALL OF THIS IS CATALITIC CON...
|2007 Dodge Sprinter 2500 3.0L MIL Lamp on VIN: WDYPE84577
warren from oregon a special thanks, shes fixed and running looked to me like when my tech installed the actuator it could move the slightest little bit and thats all it took. loosened the bolts acutated it and tightened them back up all is well. thanks guys! Trouble codes: 2513 (intake port swirl actuator position error), 2953 (intake port swirl actuator closed sensor value too high), 2952 (left ekas end position measurement sensor closed valve and readout too high).
|2006 Jeep Commander Limited 5.7L coolant VIN: 1J8HG58276
so sorry its alittle late on this. removed head gaskets and machine shop found both to be .003 warped. heads were machined and reinstalled. found a random google search that lead to checking water pump for a broken impeller and bingo. the black plastic impelle...