|Prev||Professional Automotive Repair Technical Discussions for February 6, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2006 Chrysler 300 C SRT8 6.1L Fuel Trim VIN: 2C3LA73W46
I have posted about this car previously. I have a found somthing of interest to what the computer is doing with the injector and coil control. I have confrimed that this engine is lean. During the symptom occurance when STFT are peaked postive 33%, I can add p...
|2004 Dodge Stratus SXT 2.4L transmisson
The transmission is in limp mode with a code p1751 set (trans relay always off). The problem is with the car off key on when I try to clear the codes or run function test it will not let me because the scanner says the engine is running and the conditions are ...
|2007 Jeep Wrangler Unlimited Rubicon 3.8L No start, no power windows, no wipers, headlights VIN: 1J4GA69167
I believe this Jeep has a bad TIPM but I am not able to confirm it. It will not crank. I also noticed that the power windows, blower motor, wipers and headlights do not work. I was able to determine none of the run relays are getting the ground signal from the...
|2007 Jeep Compass 2.4L p0848 VIN: 1J8FF47W37
Thanks everyone for viewing my post. I have this Jeep Compass. We had the vehicle here 2 weeks ago with the complaint of a no move. Scanned vehicle, no codes. Fluid level and condition OK. Could no duplicate symptoms and shipped back to customer. He returned 1...
|2007 Jeep Liberty Limited 3.7L Abs module VIN: 1J4GL58K67
Hi everyone. Having some issues here. Vehicle rolled into shop customer complaining of abs light and esp light. Scanned abs codes and found trouble codes for rear speed sensor circuit open. I found rear abs sensor pigtails corroded so I r eplaced them cleared ...
Fixes & Summaries for Chrysler
|2003 Chrysler 300M Special 3.5L head gaskets VIN: 2C3HE76K73
Thanks to all for replying, and giving input. I think I am safe on install and prep. The heads were properly resurfaced, torque to specs. I did the test drive, and put it on the hoist. Let it over night. Coolant started showing up around the edge of the he...