|Prev||Professional Automotive Repair Technical Discussions for January 6, 2015
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|2003 Buick Park Avenue Ultra 3.8L Cold Start Valve Tap VIN: 1G4CU54163
Customer would like to have Lower Intake Manifold removed for replacing leaking Intake Gaskets as he adds Dex-Cool Antifreeze once a week or every 2 weeks. He states he noticed Oil Pressure was lower on the Information Center Read out & the valves would tap o...
|2008 Buick Enclave CXL 3.6L Theft Deterrent VIN: 5GAEV23718
I have got this Enclave from another shop. They installed a battery and now the vehicle will not crank. It has codes B3031, B3055 and B3935 stored. The service theft deterrent system is also displayed. I tried the 10 minute relearn to no avail. I did try unhoo...
|2002 Chevrolet Silverado 2500 6.0L MIL Lamp on VIN: 1GCGK29U72
This truck sets a code p0300 while driving. It does not apperar to have a missfire. It runs smooth at all times. In scanning it shows a missifre on cyl's 1 and 6 we have replaced all sprak plugs, swapped coils replace cam and crank sensors. We have tried to re... Trouble codes: P0300
|2009 Chevrolet Suburban 1500 LT 5.3L Intermediate shaft VIN: 1GNFK26379
Customer lost 4WD shortly after we replaced the right drive axle. We found the intermediate shaft had "popped out" of the axle housing. On disassembly we found the thrust washers were distorted by some incredible outward thrust until they failed, pulling off t...
Fixes & Summaries for GM
|2008 Chevrolet Equinox Sport 3.6L MIL Lamp on VIN: 2CNDL03708
First, thanks for the replies. Jesse, I did the thrust washers when I did the chains.Special thanks to Jean...that is a good tip about cam bearing cap inspection. The customer can offer no proof of oil change history since the chains were done. He is not going... Trouble codes: P0008.