Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 17, 2014
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2003 Ford F-250 Super Duty XLT 6.0L No Start, Cuts out VIN: 1FTNX21P63
This truck is an early build 6.0 diesel. It has the dreaded hot no start condition. Ficm maintains 48 volts. When shut down after engine is warm the truck will not start. Injection pressure is below 300 and upon air test i can hear air leaking out of the front...
View
2003 Ford Explorer XLT 4.0L tcc VIN: 1FMDU73K13
2003 ford explorer, throwing codes P0740, 741, 743. followed ford diagnostics A to symptom test. witch turns around and puts you back at the same test for the codes. checked voltage at pin 3 at A/T 13 volts, checked for changing voltage between pin 3 (Batt) an...
View
2005 Ford F-150 FX4 5.4L cruise control VIN: 1FTPW14595
I have a 2005 Ford F150 Laret 4X4. With a 5.4 L engine, automatic. I have no Cruise control light on dash at all. Have power supply, checked all fuses, good, checked switch under dash on brake pedal good, System appears to be completely dead to control switch ...
View
2005 Ford Explorer XLT 4.0L odometer, radio, power windows VIN: 1FMZU73E15
hi guys thanks in advance. This is an 05 explorer that when you turn the key on it takes one to two minutes for the acc relay to finally click and the odometer power window and radio will work. tried to reset system by undoing battery and draining modules. fix...
View
2005 Ford Focus ZX4 2.0L Poor Idle Quality, Stall VIN: 1FAHP34N75
This one came in as a no crank. Charged battery, still no crank. Put power to solenoid, still no crank, voltage drops ok; replace starter, still no crank but cranks with power to solenoid. Trace starter circuit, find no ground for starter relay, condemned PCM....
View
2006 Ford Ranger XLT 3.0L No Start VIN: 1FTYR44U26
after replacing pcm I have a no start with anti theft light flashing ...this is with either pcm is there a way to bypass or reset the antitheft?
View
2008 Ford Ranger XLT 3.0L rear brakes VIN: 1FTYR44U18
1st Appointment we serviced the rear brakes, bought new drums and machine, adjust and let customer drive. Within 3 days the wheel hop was back 2nd App we serviced the shoes again, machine drums and replace spring return kit. Lasted 3 days again 3rd App we repl...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1999 Ford Expedition Eddie Bauer 5.4L Lighting VIN: 1FMPU18LXX
HI, EVERYONE I REALLY APPRECIATE EVERYONE FOR YOUR TIME TO RESPONDED TO MY REQUEST FOR HELP , WE FOUND THE SHORTAGE IN ONE OF THE TAKE OUT NEAR JUNCTION BOX, BUT I AM WOUNDER WHY IT WAS BLOWING FUSE ONLY ON RIGHT TURN !! THANKS AGAIN MATT
10
2008 Ford F-250 Super Duty XLT 6.4L MIL Lamp on VIN: 1FTSW21R38
Thank you guys for the help you offered.When I checked out the truck I did not clear codes and customer took truck and was going to bring it back but so far the check engine light has stayed off.Alldata says the life of the particulate filter is 250,000 miles... Trouble codes: P2002 (Particulate filter efficiency below threshold), B1290 (Particulate filter differential pressure too low).
8
2008 Ford F-450 Super Duty XL 6.4L Excessive Emissions, Poor Idle Quality, Misfire, MIL Lamp on VIN: 1FDXW47RX8
REMOVED BOTH VALVE COVERS TO CHECK FOR LEAKING FUEL LINES. FOUND FUEL SHOOTING OUT OF #8 INJECTOR TUBING. REPLACED INJECTOR LINE AND WAS STILL MISSING ON #2 CYLINDER. REPLACED BANK 2 INJECTORS AND MISS AND SMOKE GONE. THANKS FOR THE HELP. Trouble codes: P006B, P0234 (Turbocharged engine overboost condition), P0684 (Glow plug control module to pcm), P2452 (Dpf pressure sensor circuit a), P0266 (Cylinder 2 contribution/ balance fault), P0302 (Cylinder 2 misfire detected).
7
2010 Ford Focus SE 2.0L MIL Lamp on VIN: 1FAHP3FN5A
ok its fixed trhanks to all that replied. THis is how I ended up finding and fixing the problem I already knew there were no leaks in the tank area and I pressure tested the filler neck no leaks,tested the ftp sensor was working, so I removed the charcoal cani... Trouble codes: P0442.
10
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next