|Prev||Professional Automotive Repair Technical Discussions for November 28, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1997 Chrysler Town & Country LXi 3.8L No Start VIN: 1C4GP64L7V
This Chrysler has an intermittent no start condition due to PCM not triggering ASD and Fuel Pump Relay. Symptom only occurs Intermittently. Once engine starts, it runs fine and shows no signs of problem. However, engine Sometimes continues to run for appr. 5 t...
|2000 Dodge Grand Caravan SE 3.3L Misfire VIN: 2B4GP44G5Y
Happy Holiday Weekend. This van came in with a miss on #2 cylinder. New plugs, Swapped Wires, Checked fuel pressure & volume, Check for clicking at the injector. All seems ok but the miss is still there. Didn't see any vacuum or intake leaks. All the sensor re... Trouble codes: P0302 (Miss 2 cylinder)
|2008 Dodge Grand Caravan SE 3.3L Radio and can bus VIN: 2D8HN44HX8
Got this van here with a draw. Battery draw turns on and off about every 15 seconds give or take. Started pulling fuses but the only fuse that seems to make a difference in lowering the draw is the IOD fuse and nothing else. Draw peaks at about 1.6 amps and th...
Fixes & Summaries for Chrysler
|2004 Chrysler Pacifica 3.5L wipers/lights VIN: 2C8GF68444
thx to all who offered responses. as keith stated we also believed we had a ground issue. so we systematically started tearing the car apart to check all grounds.at ground 103 under the battery box we found 7 wires in one gound with the end still attached but ...
|2006 Dodge Dakota SLT 4.7L No Start, interrupted cranking VIN: 1D7HW42N76
Finally fixed! I'll come right to the point, It was the spark plug on the number three cylinder!! It had a TINY black dot on the upper porcelain. I had verified ALL powers and grounds to the PCM/TCM and the engine grounds. All I was loosing was the five volt r... Trouble codes: U0101 (FCM Lost communication with TCM), U0100 (FCM Lost communication with ECM/PCM).