 Prev |
Professional Automotive Repair Technical Discussions for November 12, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1972 Dodge D300 Pickup 5.2L Booster Thanks for looking. This is a farm truck, rarely used and in pretty poor condition. It is actually a 1972 Fargo 400 with a 318. It is a 2ton with 4 wheel drum brakes and a single channel brake system. The brake booster is mounted under the driver seat on the f... |
View | |
| 2001 Dodge Ram 1500 ST 5.2L master cylinder Replaced rear shoes. Did not find any leaks during inspection. After replacing and adjusting rear shoes, I noticed that the brake pedal felt spongy. Bled all 4 wheels. Pedal was high and firm. Truck came back 1 week later with brake pedal spongy and low. I not... |
View | |
| 2008 Dodge Ram 2500 ST 5.7L Hesitation, Misfire, MIL Lamp on VIN: 3D7KS28D08 Vehicle came in with MIL lamp illuminated. Code P0300 stored. We noticed a tip in hesitation from a dead stop. A very slight Misfire on cylinders 1, 3, 5, and 7 was picked up in the scan tool. Bank 1 upstream O2 sensor was previously replaced because of a P013... Trouble codes: P0300 |
View | |
| 2008 Jeep Wrangler Unlimited X 3.8L Cooling system VIN: 1J4GB39128 We have been dealing with this vehicle off and on for last 4 months. Initial problem was whooshing / gurgling noise from dash area like water moving back and forth. Drain is clear. Also fans were running and began to overheat. Level was low but did not find an... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2007 Dodge Sprinter 3500 3.0L Fuel VIN: WDPPF44517 THANKS FOR EVERYONES HELP. CONFERMED FIX, BROKEN RETURN PLASTIC "T" FITTING ON PASSANGER SIDE FUEL RAIL! |
2 | |
| 2011 Dodge Charger R/T 5.7L Engine VIN: 2B3CL5CT3B We have heat! There was a restriction in the tube attached to the water pump that runs beneath the intake. Hoses run from this tube to the outlet of the core and the reservoir. The restriction was a plastic push pin from a body clip. We had to pull the intake,... |
17 |
