|Prev||Professional Automotive Repair Technical Discussions for October 17, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2012 Jeep Liberty Sport 3.7L Misfire VIN: 1C4PJLAK0C
This Jeep liberty is difficult to start and when it does start, it runs horribly. After about a minute the catalytic converter on the drivers side glows red hot. All cylinders have 160 psi compression. There is spark to all cylinders. All the injectors are fir... Trouble codes: P0300 (Random misfire)
|1996 Plymouth Grand Voyager SE 3.3L Cuts out, Stall, MIL Lamp on VIN: 1P4GP44R1T
Have this 3.3 Voyager that runs very poorly. It will buck severely under acceleration and stall while idling. The idle also fluctuates badly. It had the codes listed. After clearing the codes, only the P1391 has come back. The CMP harness looked very bad, so r... Trouble codes: P1391 (Intermittent loss of CMP or CKP), P351/, P0123 (TPS voltage higher than maximum limit)
Fixes & Summaries for Chrysler
|2007 Chrysler Aspen Limited 5.7L MIL Lamp on, etc light on VIN: 1A8HW58227
thanks to everyone with the quick replies and the great education.we did the reflash and etc pedal relearn,could of done the relearn with my scan tool.the real problem was a broken water temp sensor the inner part pulled out of the housing but did not make and... Trouble codes: P0128, P2181.
|2002 Dodge Durango R/T 5.9L Gauges VIN: 1B8HS78Z62
Because this truck was a "no-start" almost never, it took a long time to run down the cause. Finally, after checking ALL the sensors, the ignition circuit, harnesses, and the cluster, it turned out to be the PCM. When it's a "no-start", I can wiggle the center...