Prev | Professional Automotive Repair Technical Discussions for September 9, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Ford
Help Request | Answers | |
2006 Ford F-150 XLT 4.2L mech/elect VIN: 1FTRF12226 two codes p0720 and p0722,trany shifts good into reverse but shifting into drive nothing,rev it up it will shift hard into drive and does not slip,drives good down highway,I think tranny is going out but want to make sure,what do you guys think? thanks |
View | |
2008 Ford F-550 Super Duty XL 6.4L No Start, died while running VIN: 1FDAW56R28 now on driving driver says he heard a loud noise and then truck died got truck towed in and cranks but no start battery was dead so no codes stored did KOEO self test showed current p0676 which was on previously / and p0341 cam sensor circuit performance. sync... Trouble codes: P0676, P0341 |
View |
Fixes & Summaries for Ford
Fix/Summary | Answers | |
1993 Ford F-150 XL 5.0L Cuts out, Misfire VIN: 1FTDF15N5P Since disconnecting the spout connector corrected the problem, I felt like it was a timing/spark control issue. The previous shop had installed a reman distributor. I installed a used distributor and the problem was corrected. Thanks for all the replies. |
9 | |
1998 Ford Ranger XLT 3.0L 1-2 &2-3 up shift VIN: 1FTYR14U8W Thanks to all who posted. The TPS was the problem. The voltage reading was to low. It's not adjustable but there was enough slop in the bolt holes to get the voltage back up to where it is suppose to be. I may end up in the future needing to replace it, but fo... |
7 | |
2005 Ford Expedition XLT 5.4L no communication, no crank VIN: 1FMPU16575 Thanks for the reply's, this one is fixed. Found that the central junction box could not handle the loads that where on the injector and pcm circuits with throttle motor hooked up, even though it had 11.27v and would light a 200ma test light. For some reason... |
4 | |
2009 Ford Flex SE 3.5L MIL Lamp on VIN: 2FMDK53C89 Thanks for the help, on Saturday pulled the fuel pump fuel level sensor. that one had an open circuit. installed new level sensor on Monday. Jody was correct the instrument cluster identified the wrong sensor. the code should have been B1202. When I showed the... Trouble codes: P2068 (fuel level sensor circuit high), B2627 (2nd fuel level sensor). |
3 | |
2007 Mercury Grand Marquis LS 4.6L blend door VIN: 2MEFM75W67 thanks for all the help. yes we did install a new blend door motor and so for no more problems. |
6 |