|Prev||Professional Automotive Repair Technical Discussions for August 20, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2008 Dodge Sprinter 3500 3.0L Electrical VIN: WDPPF44518
Have and electrical draw pulling down battery. Narrowed down to 2 main circuits off battery (single batt,) there are 6 main circuits. Currant wiring diagrams are vague. Seems the draw is on some type of timed circuit. Test light will birghten then dimm about e...
|1987 Jeep Comanche Pioneer 4.0L Cuts out, Misfire VIN: 1JTML63P8H
Hi group. The customer bought this jeep this summer with a rebuilt engine and transmission. It idles fine, but off idle it starts to miss and backifire. When I got it the motor mounts bolts had broken on the left side and let the exhaust/intake manifold sit on...
|1999 Jeep Wrangler Sahara 4.0L Cuts out VIN: 1J4FY49S4X
After warm-up and setting 15 minutes, this Jeep will cut out while cruising with light throttle. Fuel pressure remains constant, no codes, added fresh gas and added 'heet' to fuel in case of water in system, cleaned throttle body, replaced TPS. Spark plugs rep...
|1999 Plymouth Breeze 2.0L No Start, Poor Idle Quality, Stall, Misfire VIN: 1P3EJ46C7X
This car will start and run for a short while and then die, and will throw the P1390 code. We have checked the belt and timing, but they are fine. We are sure that it is not the belt or the timing, we can reset the code and after the engine cools down it will ... Trouble codes: P1390
Fixes & Summaries for Chrysler
|2005 Jeep Wrangler SE 2.4L No Start VIN: 1J4FA29135
Vehicle is fixed, oddly enough NVLD shorted out and must have spiked ECM. Luckily dealer was nice enough to warranty ECM, programmed properly and replaced NVLD. Vehicle is good and gone, thanks for all the replies Trouble codes: P0688, P0499.