Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for August 10, 2014
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
2006 Hyundai Tiburon GT 2.7L MIL Lamp on VIN: KMHHN65F46
Vehicle runs fine. Throw p0340 at second startup after clearing. Checked cam timing engine in time. When monitoring scan tool rise and fall or cam / crank correlation at idle will go out of spec. Spec is 36/98. When acting up will go 111/60. When rev engine ... Trouble codes: P0340 (Cam sensor code)
2000 Mitsubishi Montero Sport LS 3.0L Unknown VIN: JA4MT31H1Y
With a scanner preformed actuator switch test . at control relay , 2nd solenoid, l/r solenoid, od solenoid, ttc solenoid, and under drive solenoid, they all click, trans fluid smells good and is red. 1. 2. 3. 4 show up on scanner. but will not shift into overd...

Fixes & Summaries for Asian
Fix/Summary Answers
2006 Honda Civic EX 1.8L Poor Fuel Economy VIN: 2HGFG128X6
Well yes I think I fixed it. The jury is still out until I hear back from the customer. But because of the required time limit on how long my post can be open as per IATN standards I am forced to close this post prematurely. However I will include a summery wh...
1995 Nissan Quest GXE 3.0L Poor Fuel Economy VIN: 4N2DN11W7S
I ran a wire from the oxygen sensor signal to the engine control module and the scan tool was now reading proper switching of the oxygen sensor. The 300mv I had before must be the default value for the ECM if there is a problem with the signal circuit. I trace... Trouble codes: 34 (Knock Sensor circuit).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next