|Prev||Professional Automotive Repair Technical Discussions for July 3, 2014
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2004 Dodge Ram 1500 ST 5.7L Stall VIN: 1D7HU16D94
ran perfect before old fuel put in it.customer put bad fuel in it 2-3 gallons on a very low tank below 1/4.runs terrible stalls.fuel pressure good at 60.fuel sample smells bad,drain all fuel with relay jumped.add 10 gallons good gas.no codes,clean throttle bod...
|2005 Dodge Ram 3500 SLT 5.9L reverse VIN: 3D7MR48C85
Truck came in in limp mode, Pulled p0973 3/4 overdrive sol. ckt. Tested and found 3/4 sol open. Drop pan and replace 3/4 sol assy and harness- had to lower valve body. New filter and 8 or so qts atf +4. Fluid was old and no debris in pan. Test drive after code...
|1998 Jeep Cherokee Classic 4.0L Poor Idle Quality, Stall, Misfire, MIL Lamp on, rough idle,dtc1391 VIN: 1J4FJ68S7W
As noted above in the detailed description of my repairs and adjustments, I cannot seem to get rid of that dtc p1391. loss of camshaft crank. I was thinking of my crankshaft sensor, maybe my trigger wheel being too far away from the sensor, maybe trash stuck t... Trouble codes: P1391
|2002 Jeep Liberty Limited 3.7L Mechanical
This is my daughters vehicle , so it's a freebie repair. Dropped a valve seat and made a mess of one cylinder and head. There are no good used 3.7(2002) engines left in my area , but I can get a very low mileage (2006) 3.7. I have read about the cam and crank ...
Fixes & Summaries for Chrysler
|2008 Jeep Grand Cherokee SRT8 6.1L Starting VIN: 1J8HR78388
We were not able to fix this car, but the customer took it to the dealer and they found a section of the engine harness that was burned and shorted. The problem is apparently fixed. thanks for the suggestions.