 Prev |
Professional Automotive Repair Technical Discussions for June 27, 2014 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1986 Ford Mustang GT 5.0L Starting VIN: 1FABP28M5G starter stays engauged when starting found ignition switch wire at solinoid isnt the problem. it is diconnected and still does it. changed solinoid and starter,same thing. voltage drop across all power, ground & starter cables all ok at 0.06 volts any thoughts... |
View | |
| 1987 Ford F-150 Custom 5.0L No Start, Hesitation, Cuts out, Stall VIN: 1FTEF14N3H hello guys so i have a older f150.front and rear fuel tanks this truck has had both fuel pumps change with in months and the switching valve.at another shop so whag its doing is wen driveing after a few mimutes and i switch tank from front to rear truck starts... |
View | |
| 2001 Ford Ranger Edge 3.0L engine VIN: 1FTYR10U31 truck runs rough for first five min then fin after it sits for a three hours runs rough again. |
View | |
| 2006 Ford F-150 XLT 5.4L no start VIN: 1FTPW14516 vehicle came in on the tow truck, no start. fuel pressure is good, injector noid light test done and ok, no spark. Checked faults, have p0141,p0161(heated o2 sensors),p0740, p0443 (TCC faults) along with several other transmission faults that I thought coul... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 1993 Ford Probe GT 2.5L Clutch VIN: 1ZVCT22BXP AFTER REPLACE THE CLUTCH MASTER AND SLAVE CYLINDER, THE CLUTCH GOT PROPER PRESSURE BUT NOT COMING BACK ALL THE WAY UP. I FOUND THAT THE CLUTCH PEDAL ROD WAS NOT ADJUSTED PROPERLY TO THE CLUTCH MASTER. AFTER MAKING AN ADJUST TO THE ROD, VEHICLE STARTS AND DRI... |
9 | |
| 1996 Ford Ranger Splash 2.3L MIL Only Misfire VIN: 1FTCR10A1T I list this as "fixed" only because we were commissioned by another shop to give more definitive data and conclusions. We feel we accomplished the goal of shedding scientific light on the problem. We want to very sincerely thank all the great professionals t... |
9 | |
| 2001 Ford Ranger Edge 4.0L option package VIN: 1FTZR15E41 Thank you for all the replies! it looks like the engine swap will not be a problem 397 or 398A option is not a concern according to the dealership and iatn Thank you for all of your help and time! |
8 | |
| 2004 Ford F-550 Super Duty Lariat 6.0L Poor Idle Quality, Misfire VIN: 1FDAW56P84 So bad luck is at least luck; I guess. After checking KOEO test with a know good injector installed it passed. Ordered a "new" injector, installed it, and all tests pass. Vehicle runs great. Thank you all for your help and for taking time to comment. Trouble codes: P0268. |
9 | |
| 2004 Ford F-150 FX4 5.4L Misfire, MIL Lamp on VIN: 1FTPW14514 well thanks to about 3-4 of the replies, we borrowed a ford scanner and it showed #7 on a mode six drive, sure enough it was a bad coil. thanks to all that replied. Trouble codes: P0303. |
16 | |
| 2006 Ford Expedition King Ranch 5.4L MIL Lamp on VIN: 1FMPU17556 Thanks for all of the help requests! we tore the front of the engine down and the timing chain tensioner for bank # 2 had collapsed and it jumped a tooth. We replaced both tensioners and all guides along with chains and all is well. Thanks again for all of you... Trouble codes: P0345 (Cam sensor ckt bank 2), P0349 (camshaft sensor signal intermittant bank 2). |
5 |
