Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for June 10, 2014
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1991 Ford E-150 Econoline Custom 4.9L Egr VIN: 1FTEE14Y6M
Initially performed kore test with snap on scanner and had codes 327,328 and 332, replaced evp sensor and eliminated codes 327 and code 332,code 328 returned, tested v ref, ground and return all in specs,applied vacuum to egr valve and engine will almost die s...
View
1998 Ford Escort ZX2 Hot Coupe 2.0L No Start VIN: 3FAKP113XW
Vehicle was towed in with cranks/no start condition. Found broken timing belt,replaced belt,tensioner etc. but was unable to start due to engine damage. Installed used engine (70K)timing belt,tensioner,idler,water pump,spark plugs,crank sensor etc. Replacement...
View
2005 Ford F-150 FX4 5.4L noise like a rod VIN: 1FTPX14535
thanks everyone who reads this and if you have any ideas I would appreciate any help or advise. please read history 1st,got the truck back to see if we can find the noise, noise sounds like a slight rod noise, it also made noise with the 5-20 oil in it too. ch...
View
2007 Ford Freestyle SEL 3.0L right rear caliper VIN: 1FMDK05137
vehicle came in for used car check, customer stated needs bake work and traction control light on. test drove, brakes grinding NO traction control light. inspected brakes. front rotors badly rusted, pads worn out but normal. left rear worn to metal. right abou...
View
2008 Ford F-250 Super Duty XLT 6.4L MIL Lamp on, Limp mode VIN: 1FTSW21R88
To my fellow ford techs (or those former ford techs like myself) - does anyone have any information regarding the p016b dtc? it does not appear in any ford pc/ed manual. I googled it, with no helpful results. This vehicle is put in forced limited power mode (l... Trouble codes: P016B
View
2008 Ford F-250 Super Duty XLT 6.4L Dpf VIN: 1FTSW21R38
Truck is setting P2002 Particulate filter efficiency code. No other codes. Truck does not go into a limp mode, but will set this code after about 15miles of driving.
View
2010 Ford F-350 Super Duty XLT 6.4L exhaust VIN: 1FTWW3BR1A
Hi guys this one making me scratch my head. Is a used trunk traded in. have a 2010 ford f350 with 6.4l, truck starts right up runs smooth no missfire at all. after a 5 min test drive starts bellowing white and blue smoke so bad i cant see behind me, acully got...
View

Fixes & Summaries for Ford
Fix/Summary Answers
2000 Ford Windstar SE 3.8L Gear engagement, downshift VIN: 2FMDA5241Y
My friend is still not sure if he will buy it or not, the current owner is out of town. If he ends up buying it, he says that he will drive it until it breaks down. If things go that way, I may follow the diagnostic procedures outlines in the service manual an...
9
2003 Ford Ranger Edge 4.0L Poor Idle Quality VIN: 1FTYR15EX3
FIRST, THANKS TO ALL THAT REPLIED. FOUND OUT FROM CUSTOMER THIS HAS BEEN A PROBLEM WITH THE ORIGNAL ENGINE. WENT BACK TO BASICS AND HAD NOTICE THAT EVEN THOUGH FUEL PRESSURE WAS GOOD IT WOULD NOT MAINTAIN AFTER KEY TURNED OF. PINCHED OFF FUEL LINE AND STILL HA... Trouble codes: P2198 (B2s1 oxygen sensor rich).
12
2007 Ford F-150 XLT 5.4L Misfire VIN: 1FTPW14V37
Thanks to all. lots of great info. Turns out #1 cylinder had a broken valve spring.
23
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next